(800) 853-2651
SHOP NOW

Recent content by Brian720

Yesterday's Tractor Forums
  1. B

    William at ESC Enterpirse Group Muncie IN.

    This guy is a shady character I went to check out a piece of equipment he had listed for sale. Everything about this guy was shady Gave me the impression he is dealing in stolen equipment the way he had stuff dismantled didn"t want me walking around the place wouldn"t even let me in the shop to...
  2. B

    jd 830 2 cyl injector pump

    I had that problem once with a 720 took the rack out and had it rebuilt at a diesel shop linkage was worn and they got everything back to spec.
  3. B

    JD Classic Green Paint Codes

    Are there any paint codes for Naason Ful Thane or Dupont Chroma base or Dimension paint for the John Deere Classic Green Paint?
  4. M

    Good word for Detweiler's

    I recently purchased a set of Float-Ride seat rubbers for a tractor of my own from Detweiler's in Wisconsin. They separated after a few hours use. They sent me another set that ended up doing the same thing. Long story short, they took care of my problem and made it right. With all the...
  5. J

    1955 FORD 600 Series Tractor

    It has a 3 point hitch and rear PTO my problem is I'm not sure what type of fluids I need to use. What type of fluid does it use in the transmission? What type of fluid goes into the Hydraulic Reservoir? What type of fluid does it use in the rear end? It has 3 port holes for fluids 1 at the...
  6. B

    1952 JD A not runing right

    When we pulled the drain plug on the bowl of the carb there was a good steady stream of fuel that came out.
  7. B

    1952 JD A not runing right

    A friend of mine has a 1952 A that we just overhauled. Everything in the engine was replaced with new. Carberator was sent to Dennys Carb Shop and rebuilt. Tractor ran perfect for maybe 10 hours or so then just had it setting there idleing and out of no where it just starts sputtering every 4...
  8. B

    How to wire up an alternator on JD 420

    The batery has been hooked up negative ground, when I got it with the alternator already on it. The problem was the wiring harness was shot and I put one like the origional on it and want it to be hooked up right so that it charges. The generator has one post to hook a wire to.
  9. B

    How to wire up an alternator on JD 420

    I have a 420 I aquired and am wondering if there is a proper way to hook the alternator up using the origional wiring harness. Do I just leave one of the two wires that were origionally for the generator unhooked? Is there anything else that will have to be changed over, such as voltage...
  10. B

    Farmall C hyd. pump

    When I took the lines off I took an air hose and blew in both holes where the lines go into the block with the lift arms, the arms go to the rear position as soon as air is blowed in there but they don't go to the forward position unless I help it out by hand while blowing air in that hole. So...
  11. B

    Farmall C hyd. pump

    I have a farmall C and the hydraulic pump gets hot when it is ran for afew minutes. The lift arms have never worked on it since I got the tractor about a month ago. When I take the lines going from the resivour to the pump off there is oil in the pump, so that leads me to believe that the oil...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top