Recent content by BUCK CLAYTON

  1. B

    I hope not

    Like about 40 yrs ago was mowing pond dam covered with thick Bermuda , 8 inches high. Had in 1st gear with brush hog low. Had to go wide open to kep from stalling. At once tractor started knocking . Got back to barn , found noise in 1st cylinder using 1in. Heater hose to listen with. Took head...
  2. B

    Thanksgiving

    Yes, it is a good day , end of harvest. Hello an have a nice thanksgiving. Buck
  3. B

    Farmall H seat

    On your 1945 H, to put the 4 bolt seat on, you will have to replace original pipe seat with the new type deluxe coil spring seat with shock absorber. You can either use the 1947, 48 or early 49 deluxe seat frame with the long shock in back of spring or the late 1949 to 1953 seat frame with the...
  4. B

    Farmall M

    This casting is 1950. There should be a cast # on r. side of motor above dist. Example, 6-25-T is June 25 1950. These dates are on all castings of tractor. Buck
  5. B

    Drove this H home from an auction Sunday.

    D Slater is right on . First thing to do is look at that serial no. It should match serial no. on clutch housing. The oil filter is for middle of 1942 back to 1939 and front wheels correct for tractor below 1949. looks like a early 42 down to middle of 1940 model with new wide r. rims.Does it...
  6. B

    IH SALVAGE YARDS

    THANKS FOR THE REPLIES. HELPS A LOT. GOT TO GET TO RED POWER NOW. BUCK
  7. B

    IH SALVAGE YARDS

    Are there any IH SALVAGE YARDS in the S. W. corner of Mo.? Thanks for any help. Buck
  8. B

    Correct placement for Diesel decal on SMTAD topic PICS

    Mkirsch; A farmer that lived near us bought a new 1947 M and it had the first new seat with shock in rear. I got to do a lot of plowing for him and by 1950 ,70% of red paint was gone and decals were bad. I was 14 then and thrilled to death to get to work that tractor again. Buck
  9. B

    AG in IN seat shock

    D Slater, My 46 H had that same shock set up on it. Bought in 1968. Always thought it was a farmer add-on. It worked real good. Much better than just small spring. Buck
  10. B

    Steering Wheel on Early H M

    The steering wheel is correct for 1939 & early 40 M's an H's. This is a picture of a new 1939.or very early 1940 H.It has the flat rim 36 inch wheels, channel seat, hard rubber steering wheel, small pto with round clamp-on cover, the green an white cross for safety decal above pto, the slant...
  11. B

    Need Starter Help for 1950 Chevrolet - OT

    You will have to take it off to fully check it out.Usually if the starter is spinning you will need a new solinod.If it was me, I would take to starter shop an have gen. up graded to 1954 specs.. The 235 only came in power glide deluxe Chevies and had hydrolic valve lifters. After a few years...
  12. B

    47 Farmall M hood decals

    As for the hat. It was probably a new hat that had the IH decal logo on it.IH FORGOT or didn't think to paint the IH on because they started using the IH symbol nearing the end of 1946. Our 46 H made in Dec. had the IH & Mc Cormic Deering on it. The muffler pipe was only about 5 in. long, also...
  13. B

    Impeller&shaft and dissasembly help MODEL H WATER PUMP

    MY 39 M had a hot water tap from top r. rear of head where temp. gauge is, using a T pipe.That line runs around back of motor to the Ensin unit near carb. and their is a line going to lower cast iron pipe to radiator. No water line fm. water pump.This tractor uses standard water pump. This...
  14. B

    correct seat for 1943 H

    Not counting the 1939 & 40 angle bar seat that went down in the cut out wedge of trans. cover. Buck
  15. B

    correct seat for 1943 H

    Kevin; The picture of the pipe seat was the only seat I have ever seen on H or M's from factory till 1947,then first coil spring seat with long shock behind spring came out as extra cost item. We had a new 1942 H and it had the pipe seat with sponge rubber & black canvas on it. Buck
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top