Recent content by Butch T.

  1. B

    John Deere 420U lift height

    Thank You for the advice! I will look up those friction disk. As for a manual for the cutter I don't know what it is. There are no tags or numbers on it. It was repainted when I bought it . The original paint was a pale green.
  2. B

    John Deere 420U lift height

    I also want to know if the lift lever is supposed to move back to the up position on its own? When I push it forward to the height I want it wants to move back to the top position. I do see a bolt with a washer . Is that the stop.
  3. B

    John Deere 420U lift height

    Hi, I attached my brush cutter to the tractor and when I lift it up it seems really high. There are two set of pins on the brush cutter.Should I be using the upper pins?
  4. B

    Brush Cutter

    Thanks for the tips. They are much appreciated.
  5. B

    Brush Cutter

    Hi, I have another questions. After watching numerous videos on brush cutter setup and operation. I wasn't sure what pins I should attach the drag links to. I used the bottom pins and it allows me to raise it at least 2 ft or more off the ground . Is that correct? I also wasn't sure what hole...
  6. B

    Brush Cutter

    Thanks, No it is a 420U. I am slowly refurbishing it. The old Popper still running strong.
  7. B

    Brush Cutter

    Richard, Thank You for the help. I took a picture of the gearbox. It looks like it had a tag on the front of it but it had been painted over. I used the cutter and it performed well. I did notice on the side where some of the paint had come off it looks like the original paint was green.
  8. B

    Brush Cutter

    Thanks for the input. I tried to upload some additional photos but they didn't send.
  9. B

    Brush Cutter

    Here are a couple of photos.
  10. B

    Brush Cutter

    Thanks, After I used it . I noticed some pale green paint on one of the sides. I did find a number on the gear box. I think it says NA50-1. This post was edited by Butch T. on 08/06/2023 at 04:00 am.
  11. B

    Brush Cutter

  12. B

    Brush Cutter

  13. B

    Brush Cutter

    Hi, Was hoping the community could help identify a brush cutter I recently bought. I have looked for tags but haven't found any. Thanks
  14. B

    John Deere 420 U Hydraulics

    Thank You, Newbie question . What is the remote coupler used for? It took me a few seconds to see what you were referring to about the draft link pin . Thanks for pointing it out. Will get the wrenches out.
  15. B

    John Deere 420 U Hydraulics

    No it isn't the PTO Lever. I uploaded some new pictures. Hopefully they came through.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top