Recent content by buzzin duzzin

  1. B

    What to do

    have you tried prayer ?
  2. B

    oliver 2255 compressor mounts

    I will give it to you , you pay shipping , did my e-mail address come thru on my first response ?
  3. B

    oliver 2255 compressor mounts

    I have some off a 3208 dont know if they are same
  4. B

    806 power steering pump

    mcv pump supplies steering p.s.i. & g.p.m. through a priority flow divider was all of this working?
  5. B

    400 Power steering

    i have a 450 with a behlen unit & a dedicated pump, it works almost as good as the hydrostatic steering on the 656. my 350 with behlen unit & priority flow divider pulling oil from the hyd, pump does not work as good. yes u can rebuild/re seal the unit
  6. B

    Big Roy

    it never went into production Heritage Iron magazine had some info on it (i think )
  7. B

    Disesl Feul

    we have ran B11 (11% bio) for several years & several gallons & have a list of do's &dont's: do not use bio in anything that is not used very often, do not use in anything that has a steel fuel tank, do not have your supplier put fuel in your storage tank until it is empty. do put a fuel...
  8. B

    856 TA

    things to consider for diagnosing a IH hydraulic T.A. A female splined collar attached to the pressure plate engages a splined hollow shaft that provides "live" power to: M.C.V. pump & circuit, hitch pump & p.t.o. . A solid shaft splines to the clutch disc. The m.c.v. circuit (among other...
  9. B

    IH weight bracket weight lock

    that piece is a angle iron , u will also need two eccentric gizmos that squeeze weights together
  10. B

    D358 IH with VE injector pump

    if you have a bosch single plunger pump remove the housing or cover on the side of the pump head. Bar the engine over until the stationary mark lines up with the mark on the gear tooth. other brands of pumps are a lot alike. This, of course, is assuming the pump has been timed correctly by...
  11. B

    350D starting

    my 350d was never a strong starter even after a complete restoration. it got a little worse each year and even acted like a vapor locked gas engine if u attempted a restart when up to temperature. i finally recalled that my pump guy said the hydraulic head was marginal. purchased n.o.s. pump...
  12. B

    1755 steering cylinder

    a spiral EZ out will remove it, they are a taper fit, another thing to check is slide flare nut back & look for crack on line
  13. B

    350 diesel

    compression & fuel injection system need to be up to snuff. a block heater is nice . a good machine shop can make a water pump hub/ housing out of steel . have engine balanced they vibrate
  14. B

    Oliver 1950T Repower

    talk to Brad at Maibach tractor 800 808 9934
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top