(800) 853-2651
SHOP NOW

Recent content by Case52

Yesterday's Tractor Forums
  1. C

    1952 Case-How to replace a grease seal behind the brakes

    12/01/16 Well I had to do the one oil seal over Because when you take the plate off and put the seal in and try to get it over the shaft that dropped is not good. The weight of the shaft smashes the rubber and the seal leaks bad. Doing the job over I did'nt take the plate off, I drilled 3...
  2. C

    1952 Case transmission drain plug

    12/01/16 Thanks for the pictures. I have an old Case book doesn't show nice pictures like that. These pictures are hydraulics drain plugs. I was looking for the tranmission drain plug and finally found it. It is to the right side of the tow bar under the transmission. It is not a bolt...
  3. C

    VAC Starter Drive Bendix

    12/1/16 I have a 1952 Case Vac. My starter drive has been grinding for years and if I grind it long enough or turn it over with the hand crank it would turn over. My starter drives would only last a year and I would replace, last time I got so desperate I reshaped the starter drive gear...
  4. C

    1952 Case transmission drain plug

    11/21/16 My transmission fluid was old and I replaced it with 90 wt. but I over filled it. I have a hydraulics fill hole I use 10 wt. and a transmission fill hole next to the shifter. But I can see only one drain plug under the transmission. My book says nothing. Anyone know if...
  5. C

    1952 Case-How to replace a grease seal behind the brakes

    11/21/16 Thanks for the heads up on the brake oil seal for the 1952 Case. I overfilled my transmission with new 90 weight. I can't find the drain plug. I have a fill hole for the hydraulics right below the sediment bowl for the carb and a fill hole for the transmission next...
  6. C

    1952 Case-How to replace a grease seal behind the brakes

    11/17/16 I got the plate to line up only by taking both back wheels off so there was not any weight on either shaft. It frees up both shaft on each side to line that plate up, but smashes the rubber on the new seal when you put it back together. Like you said pull it without pulling that...
  7. C

    1952 Case-How to replace a grease seal behind the brakes

    11/17/16 I will admit I will never take the 4 bolt flat plat that contains the seal off ever again. When you take off that plate to knock out the seal everything is great, but try to put that plate back on with the seal in it. When you pull that plate the splined shaft inside the trans...
  8. C

    1952 Case-How to replace a grease seal behind the brakes

    11/16/16 I did not know that. This is the only tractor I have had for 41 years. I have a 1952 Case Vac. I just did a clutch, turned out great. The brakes are under the foot board in drums that come out of a shaft from inside the transmission. I pulled everything apart had the brake...
  9. C

    1952 Case-How to replace a grease seal behind the brakes

    11/15/16 I am having trouble getting the square 4 bolt plate with the seal back on the 4 studs sitting on the side of hthe transmission. The plate has a 1 inch inner howsing that fits into the transmission case very tightly and it won't line up. Any help appreciated. Larry
  10. C

    How to adjust a clutch on a 52 Case

    11/5/16 I finished putting in the clutch on the 52 Case. It says 11/2 -2 inch free play. I have the clutch pedal so it is loose 11/2 inches from the foot platform to the clutch pedal and there is no gear grinding. Is that Free play?
  11. C

    1952 Case clutch torque setting

    10/03/16 I am putting a new clutch in my 52 Case. I flipped the ring gear on the flywheel put a little bevel in the new ring gear side and had the clutch rebuilt. Now I am installing. When I put this clutch in 20 years ago I tightened everything up full force. This time I was doing the...
  12. C

    1952 Case thermostat change

    02/08/16 Are the rust inhibitors and protections in the antifreeze or do you have to buy them. I drained my old antifreeze and it tested -40 with the ball test. I tested new 50/50 from 2 different companies and it tested 0 even though the jugs said -34. So I put my old back in and added...
  13. C

    1952 Case thermostat change

    02/06/16 I have had the 52 Case since 1975. Have used it winter and summer. I have neglected to keep up with antifreeze and thermostat changes. The only thing I did is have the radiator soldered 15 years ago and add antifreeze here and there. My question is: when I drain the antifreeze...
  14. C

    1952 Case starter button

    12/29/15 Thank for the info. This is a different set up. There is no solenoid. The starter cable is connected to the starter button. The starter button is connected to an on/off switch. The positive on the battery go to the starter button. Wires from the on and off go to the chevy...
  15. C

    1952 Case starter button

    12/29/15 That's a possibility. I have had this starter for about 25 years. It spins over fast. My spark plugs wires, distributor cap and points are about 20 years old. Everything was working fine til I put a new starter button on last spring. This tractor has been very good to me...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top