Recent content by Cb8128

  1. C

    Hi crop

    Hello, I have found a JD high crop 7400 somewhat reasonably priced. I was wondering what all would it would take to convert to a standard tractor. One place I called had axle housing and rims and they said 8-10,000 to convert it. Does that sound about right.
  2. C

    7700 rear Hydraulic remotes leaking

    Yeah I was meaning the female fittings. I believe they leak even when nothing is hooked up to them.
  3. C

    7700 rear Hydraulic remotes leaking

    The rear remotes on our 7700 is leaking pretty bad and I was wondering ifanyone had any advice to help stop the leaks or a part number to replace them. I've looked online a little to just replace them and haven't found much. Thank you
  4. C

    7700 PTO keeps spinning

    So we have a Ford 7700 and the PTO is constantly spinning unless you have a pretty good load on it like the baler. What do I need to look into? From my research it looks like possibly a broken brake band or weak hydraulics. With the tractor off you can spin it with some mild effort, another note...
  5. C

    2750 loss of steering

    Yeah we put a new filter on and cleaned out the screen, it was clean. And I believe the loader is closed center
  6. C

    2750 loss of steering

    Today we were using the 2750 for brushing hogging, and it was losing hydraulics, so finally narrowed it down to something with the PTO.
  7. C

    2750 loss of steering

    Alright, we have a little more to bale so we will give that a try next time and see if that makes a difference.
  8. C

    2750 loss of steering

    So we have been baling with our 2750 front wheel assist and just recently it seems that once we get about 3/4 of a round bale we will loose hydraulics to the steering. We are able to tie the bale and kick it out but the hydraulics seem weak. After kicking the bale out it seems to work normal...
  9. C

    JD 4010 hydraulics

    We figured out our issue, we have a control valve tied in for our loader.. we capped off the line running to the control valves for it and that solved our problem. Evidently that was leaking through and not allowing it to build pressure. The man that rebuilt our pump said it was about shot and...
  10. C

    Re: JD 4010 hydraulics

    The control valve for the loader was leaking by. Now it's time for a clutch
  11. C

    JD 4010 hydraulics

    Well we replaced the hydraulic pump, and it didn't solve our problem. We still are reading around 800 on the gauge at the back of the tractor. We will have to check and see if the transmission lift pump is supplying 5 gpm
  12. C

    JD 4010 hydraulics

    We did clean out that screen and it had a lot of junk in it at the time we replaced the brakes. It's ran maybe an hour since then, it could possible have some stuff in it again but I haven't checked yet.
  13. C

    JD 4010 hydraulics

    We replaced the filters and fluid after redoing the brakes but that didn't make much of a difference. How's the best way to check the transmission pump flow. We just hate to pull the pump off if we don't have to. But it's looking like that may have to happen.
  14. C

    JD 4010 hydraulics

    One bit of information I left out was that the bakes pads were shot and there were particles and minor pieces of metal in the oil and filters. We took the rear housing off and replaced the brakes and used a magnet to dig out a half coffee can full of crud in the transmission housing. We then...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top