(800) 853-2651
SHOP NOW

Recent content by cdziadek

Yesterday's Tractor Forums
  1. C

    Case 970 PTO problems

    So my father in law tried to make the biggest round bale in history and smoked the pto clutches in my 970. Had new clutches put into it but now it will turn when you engage pto but I can grab it with my hand and stop it. Is there a setting on the valve under right fender to increase pressure...
  2. C

    Perkins engine transplant....will it work?

    Hey everyone, so I have a low houred 354.4 from a 850 massey combine, however I noticed the pulley on the flywheel is different than my 105 and 85 whites. I guess my question is can it be transplanted easily into these tractors or do you need to switch the crankshaft to make the pulley bolt on...
  3. C

    2-85/2-105 doing stationary pto work question

    Yeah that makes sense. Thanks again
  4. C

    2-85/2-105 doing stationary pto work question

    Yeah I have a 970 case with the powershift also so I was aware of that one just newer to the white/Oliver O/U. Thanks
  5. C

    2-85/2-105 doing stationary pto work question

    Is there a safe place to run the over/under on these tractors when doing stationary pto work like on a grain vac or auger. I thought I read somewhere before that you don't get oil to certain top shafts in the trans if not in the right spot? The trans lube light flashes periodically on my 105...
  6. C

    2-85 white tractor - need help please

    Thanks again everyone for all your help and ideas. Turns out the clutch disc was stuck to the flywheel. Sprayed brake kleen and drove it 100 ft, as soon as i shifted it with the O/U with the clutch pedal pushed in it freed itself. Looking forward to putting it to work on a haybine this...
  7. C

    2-85 white tractor - need help please

    It was working good last summer when I drove it on and off the lowbed and around the yard.
  8. C

    2-85 white tractor - need help please

    Yes I actually have at least a 1/4 inch between the plug or dummy shaft and the snap ring. Will give it a pull with our wheel loader later today or tommorrow and see if that cures it. Thanks for the help!
  9. C

    2-85 white tractor - need help please

    So I have 2 of these 2-85 white tractors. One had a bad trans but recently overhauled engine and clutch. So I pulled it complete with powershift and put it in a low houred one. Installed pto shaft I believe to be all the way forward. Now I can't get the clutch to disengage with the pedal...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top