(800) 853-2651
SHOP NOW

Recent content by ChevellRCR

Yesterday's Tractor Forums
  1. C

    Deere 70 Advice

    lol ok Speaking of money and HP.... So I'm going to have to pull this 70 down and replace the crankcase. I got the tractor as part of a package deal with another tractor as it needs work. The tractor was ran on too low of an octane fuel, pre detonated and cracked the crankcase from the main...
  2. C

    Deere 70 Advice

    Yeah I have read that about deere costing so much more. I did get the 70 but only because it came as a package with another tractor I was looking at. I know I'm behind the 8 ball making these work but my buddy has a couple old Farmalls and I just want to have some fun and give him a run for...
  3. C

    Deere 70 Advice

    Near Columbia SC
  4. C

    Deere 70 Advice

    That sounds like a very nice combo and she's doing a great job. I know I need high octane fuel like that so I have to find a local supplier.
  5. C

    Deere 70 Advice

    Thank you. I have so much to learn.
  6. C

    Deere 70 Advice

    I'm looking at buying a 70 that has already had a lot of work done. I was wondering a 70 can be competitive pulling or is it a waste of time. The tractor has been modified with an 8 inch stroke and it has a power block which is bored out to 6.625. It has been lightened by deleting the power...
  7. C

    JD A Pedestal Question

    I knew in my mind that is wouldn't but I still wanted to be sure. Thank you for taking the time to answer.
  8. C

    JD A Pedestal Question

    I have a 1945 A with the standard front axle and was thinking about converting it to a rollomatic. There is a junk B right up the road with a rollomatic front end on it but it's a 1950. I'm at work so I can't measure it right now and I doubt it will but will a B pedestal swap over to an A? If...
  9. C

    Need a PTO parts for 1950 John Deere G

    OK... Got the cover off and it looks like I need everything. Pump gears, shaft and anything else that would be needed to slide those items in place.
  10. C

    Need a PTO parts for 1950 John Deere G

    Thank you. Just what I needed.
  11. C

    Need a PTO parts for 1950 John Deere G

    Thank you and I will try to get it opened up in the next few days. Glad to see you have parts though. Do you or anyone have a parts schematic for that area?
  12. C

    Need a PTO parts for 1950 John Deere G

    I recently bought a G and want to add a few items to the machine. It was being used for antique pulling and had a custom bracket where the drawbar would be. For this bracket to work properly they removed the PTO shaft and blocked it off with a cover. I'm going to add a 3 point hitch...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top