(800) 853-2651
SHOP NOW

Recent content by Chip H

Yesterday's Tractor Forums
  1. C

    Briggs 23D no spark

    Thanks Fritz! I reduced the air gap as yo7 suggesrlted and went back to the points/condeser set up...she's now running like a champ. Thanks for sticking with me, I wouldn't have gotten it orherwise!
  2. C

    Briggs 23D no spark

    Its the module itself, using separate coil. You're totally right Fritz, there aintmuch to it which adds to the frustration. Coil's got clean ground and primary's clear. I'm going to try your other suggestion of reducing air gap, just got to pull the motor again.
  3. C

    Briggs 23D no spark

    Ok, thanks Fritz, I'll give it a shot. How can you test if the electronic module is bad?
  4. C

    Briggs 23D no spark

    Thanks guys. I've rung out the whole system to eliminate grounding issues with kill wire eliminated and ensured good coil ground. Flywheel key is intact, tight and hasn't moved land coil windings can really only go in one way since the spark plug lug is on the face not coming from the top...
  5. C

    Briggs 23D no spark

    Thanks Geo. I should prob just bag the magneto and go this route. Ive seen wiring diagrams with ballast resistors incorporated but that may be for multi-cyl engines? Anyway, thanks for your help!
  6. C

    Briggs 23D no spark

    Gents, thanks for the quick responses. OTJ, I get 7.33 ohms] from the coil between the spark plug wire and windings wire from the coil. Also .3]])) between windings wire and ground (neg. Grnd)) There's oly 3 wires off the coil, spark plug, braided neg., and coil windings lead (to points)...
  7. C

    Briggs 23D no spark

    Hi guys, I read through old threads on this topic but couldn't find a solution so I'm throwing it back out there, hoping someone can help! I have a 23D with no spark as well. I replaced points, plug and condeser and gapped to .020, still nothing. Kull wire is disconnected so no grounding issue...
  8. C

    Briggs and Stratton 23D Plunger

    Hi guys, I know this is an old thread but hoping we can pick it up. I have a 23D with no spark as well. I replaced points, plug and condeser and gapped to .020, still nothing. Kull wire is disconnected so no grounding issue from there. I replaced the coil with a fresh winding from...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top