Recent content by Chuck Reynolds

  1. C

    trustworthy 4430 engine rebuild kits?

    Appreciate the guidance on importance of new fasteners. I worry about poor quality kits. Are there any yall have found are more trustworthy?
  2. C

    trustworthy 4430 engine rebuild kits?

    Is there a trustworthy 4430 rebuild kit with: liners; pistons; rings; bearings; etc. Saw the following youtube video and at 7:40 they show a Maxiforce kit. A few videos later, after quite a few hours of run time, unexpectedly something broke the block from inside out.
  3. C

    john deere 2510 injector leak

    Thank you. The Ts solved the leak.
  4. C

    john deere 2510 injector leak

    That's certainly the easiest thing to do. The T boots look nice, but of course one could have failed. I'll look get hood off and look closer. Will a single broken T put out diesel at a rate where it runs down block and creates a 6 inch damp circle (fast dripping) on concrete in 20 -60 seconds?
  5. C

    john deere 2510 injector leak

    All, Recently put on new fuel filter, tractor has been in shed but not used but once this year. Today ran it for 45 minutes dragging off tree blown over by storm. Everything seemed normal and good. Parked it in shade for 2 hrs afterwards. Came back and as soon as it started saw diesel running...
  6. C

    john deere 2510 steering motor leak

    Much thanks to Tim for the great tips. Got it back together mid week. It's doing good. FYI. According to John Deere the bearing is no longer available. Luckily didn't need it.
  7. C

    john deere 2510 steering motor leak

    1) Thank you. 2) FYI. Confirmed. The piston is prohibited from sliding out as shown in picture. Have it disassembled as of today.
  8. C

    john deere 2510 steering motor leak

    This post was edited by Chuck Reynolds on 10/02/2023 at 03:39 pm.
  9. C

    john deere 2510 steering motor leak

    Have 2510 with steering motor leak. Have rollomatic front end removed and right side (as sitting in drivers seat) frame rail removed. Planning to replace piston O-rings, piston backup rings, and spindle seal. For timing purposes, was hoping mark piston depth in bore first before...
  10. J

    John Deere 620 LP / Propane Engine Stalling

    Hello, new to this forum, and first post here. Short background: I?ve spent the several weekends over the past few months trying to get an old family John Deere 620 to start. Last weekend I finally had success and got the old tractor to fire up. I?ve fought fuel, ignition, and compression...
  11. J

    Ford serial number

    Just acquired a Ford 1000. Where to find serial number plate for the Bill of Sale?
  12. C

    4430 selective control valve leak from cap (31)

    Tim S, On Friday pulled housing from tractor and reassembled slowly and evenly with everything in horizontal position. Seals and o-ring stayed in place with grease. No more leaks and tractor hydraulic operation seems normal. Thank you very much!
  13. C

    4430 selective control valve leak from cap (31)

    Tim S, Thank you. It does help me. Glad the housing to rockshaft housing gasket is reusable. Will try to get home from work early one night to pull housing and try to install cap as shown in your picture. Thanks so much!
  14. C

    4430 selective control valve leak from cap (31)

    Fellows, Thanks for the input. Kind of looked like one had to be part octopus to reinstall on tractor. Sounds like y'all strongly recommend getting housing off tractor and to put cap on in a horizontal way. QUESTION: By removing c clip from linkage, assume that removing housing will...
  15. C

    4430 selective control valve leak from cap (31)

    Have fluid leaking out from under cap near turtle-rabbit adjustment arm on 1973 4430. Pulled off cap and obtained new valve guide o-rings(20); backup rings(21); o-ring(27); backup ring(28); thrust washer(29);o- ring(30); 6 packings for cap. Have it all ready to install onto the housing...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top