(800) 853-2651
SHOP NOW

Recent content by cjgarnett

Yesterday's Tractor Forums
  1. C

    Allis #33 corn picker fans

    Charles I was wondering if you found a set on the junk wagon?
  2. C

    Allis #33 corn picker fans

    I am in Hopkinsville, KY. Western Kentucky. Not too worried about distance.
  3. C

    Allis #33 corn picker fans

    I am trying to mount a #33 picker on a WD/WD45 and am having trouble finding a set of fans. Can someone point me in the right direction to find a source?
  4. C

    Allis mounted corn picker

    I am looking for a Allis Chalmers WD or WD45 with a mounted Allis Chalmers corn picker. I would consider a picker without a tractor if necessary.
  5. C

    Farmall C carburator

    I have a Farmall C with a Carter carb and the only identification I can find is on the throat. It has UT 0-653 on it. I understand that these cannot be completely rebuilt. Can someone tell me what the exact fit Zenith is?
  6. C

    '46 John Deere B governor issue

    Thanks to all. The flat spring made the difference. Engine immediately took off. Can't believe how weak that spring was.
  7. C

    '46 John Deere B governor issue

    I've adjusted the bolt as far as it will go and it has no effect, just bends the spring more.
  8. C

    '46 John Deere B governor issue

    Bernie was yours doing the same thing mine is? How much trouble is it to replace the spring?
  9. C

    '46 John Deere B governor issue

    I am having a problem getting the John Deere B engine to come up to high engine rpm. The most I can get out of it is 1070 rpm. Governor linkage and throttle linkage has been adjusted to specks. Engine runs fine on a dyno except for the rpms not coming up to 1340. Governor seems to control...
  10. C

    600 Ford Fuel tank valve:(Ideas for a BETTER replacement???

    Tony do you have these rebuilt valves for sale? Charles
  11. C

    John Deere B magneto timing

    That's what I wanted to know. I studied his process and wondered if I really needed to do all that. Sometimes this tractor is hard to start and other times it starts easily. It seems to be an ignition problem. I am having the mag rebuilt because it doesn't seem to have a very hot spark...
  12. C

    John Deere B magneto timing

    John I have Duane Larson's method. I couldn't find anything about setting both the running and impulse timing anywhere but in his method. I was wondering if I needed to do both or just what the JD-B service manual said. His sounds a little complicated but if I need to do it I sure will.
  13. C

    John Deere B magneto timing

    I have a John Deere B with a Wico XH1042 magneto with drive cup 6274. It says 25 deg. on the cup. Is this supposed to be timed to impulse on TDC or is there another timing process to go through?
  14. C

    Fast Hitch Plow gauge wheel

    Did you find a gauge wheel for your plow?
  15. C

    Value of a 1 Bottom Newgren Plow for a Jeep CJ2A

    Do you still have the plow and are you interested in selling it?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top