(800) 853-2651
SHOP NOW

Recent content by Claven2

Yesterday's Tractor Forums
  1. C

    Charlies no parade king

    Great tractor, nice to see an SC with the cultivators. I wish I had them for my SA. Mine hauls a lot of brush too, and runs a hog, drags logs, plows gravel, and, and, and... :) All that aside, charlie would benefit from a coat of paint. Nothing fancy, but paint is better than...
  2. C

    our f 12

    Looking great! Are you going to keep rubber on it, or those steel wheels in the back?
  3. C

    Need price help

    I doubt anyone will bother to help you if you can't even be bothered to post a photo of the condition. Just saying.
  4. C

    Help- name this piece and find a source

    If it's original IH, it will have the part number cast or forged into it somewhere. Have you cleaned it up to look?
  5. C

    c engine block

    I hear ya. I run antifreeze in my SA for just this reason. Too paranoid not to!
  6. C

    Drawbar Help Please

    FWIW, some of the holes in the FD for the Super A are not blind, but go all the way through. They are threaded though.
  7. C

    c engine block

    Bummer. How'd you crack it?
  8. C

    Drawbar Help Please

    Ya, I didn't catch that it might be the earlier A arrangement. It would be helpful if the OP provided pics of the DB and the FD arrangement he is trying to connect to?
  9. C

    Drawbar Help Please

    Whoa! Time out! The drawbar normal does NOT bolt directly to the final drives. Normally there are threaded studs that install in the final drive, then a pair od drawbar plates bolt to those studs, and finally the drawbar hinges on the sold studs that protrude from the plates. Doe you have...
  10. C

    H Oil Pressure Problem

    Not sure about an H pump, but many of the letter series pumps are known to have erratic oil pressure readings as the pump cover plates wear. It basically results in oil bypassing the pump gears at times and lowering pump performance. IF you had that problem, the fix would be to replace or...
  11. C

    How does this valve work?

    So the Formal 100 (Formal Super A) is a garden tractor? Interesting take. The valve looks a LOT like an Auxiliary Control Valve, as sold on some Formal 100'a and Super C tractors. Basic 2-way hydraulics. Only intended for either one cylinder, or two cylinders if both are to be operated in...
  12. C

    c engine block

    As I understand it, mid-way through 1952, IH standardized on the 123 block for all A and C variants. The difference between a C113 and C123 configuration after this point is which cylinder sleeves and pistons were installed. The block/head assembly itself was the same for both tractors...
  13. C

    400 - - broken steering bracket - cause ?

    that one has been repaired at least twice. A good weld shop could fix it again, I think.
  14. C

    farmall A 192 plow

    Any steel part could be built up with weld and re-shaped, but plow shears are not expensive. Check e-bay.
  15. C

    SC Touch Control reservoir lubrication

    It depends on whether you borrow implements or not and whether you have an auxiliary control valve. If contamination is not an issue, you could run any reputable hydraulic fluid, or even plain 30 weight motor oil.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top