-
J
Hauling a Gleaner F
How much does an F without the head weigh? Will a Ford F450 dully with a 12,000 lb. gooseneck handle it? Trailer is maybe 3" high. How high is the F? Or,,should I just let a local tractor dealer go get it. Its about 70 miles. Don"t really want to drive it home. I seem to be cursed when it comes...- John Harry
- Post #1
- Forum: Combines and Harvesters
-
C
640 Hydraulic Lift?
Removed unloading valve,o-ring worn,need to replace it.Must be a special o-ring.Having trouble finding the right one.Also removed the safety valve and the spring was broken.Need to replace it also.Are these o-rings a dealer only item? -
C
Ford 641 Carb...help!
Have you checked the glass fuel bowl to see if it is full of rust?Also when you remove the bowl make sure you check the screen also.My 640 does the same thing sometimes. -
C
640 Hydraulic Lift?
Okay Guy"s!!I had to change the relief valve on the bottom of the housing and now the pressure is 2200PSI.Still won"t lift.No visible leaks inside.Removed the lift cover and put it in a vise with lift arms looking up.When I put air to it with the lift handle in the down position the piston will... -
C
640 Hydraulic Lift?
Okay Guy"s!!I had to change the relief valve on the bottom of the housing and now the pressure is 2200PSI.Still won"t lift.No visible leaks inside.Removed the lift cover and put it in a vise with lift arms looking up.When I put air to it with the lift handle in the down position the piston will... -
C
ford 631 tranny shifter problem
The pin I"m talking about is in the gear shift handle just below the cover plate for the gear shifter.The shifter will come out if you remove the cover plate that is located between your feet when you are sitting on the tractor.About 8 bolts holds it on.And do not move any gears after the plate... -
C
ford 631 tranny shifter problem
Should be a pin in the ball on the shifter.Either the pin is worn or the slot that it rides in is worn.Pull the shifter plate and check. -
C
640 Hydraulic Lift?
Your right about the gears making the oil splash!I've got pressure back to the top of the lift arm cover plate!I'm wondering about the relief valve or check valve at this point!What do you think? -
C
640 Hydraulic Lift?
My 640 will not lift at all!The pump is primed but there is fluid splashing in the transmission in front of the gears.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy