-
C
4020 diesel injector pump timing
Thanks all you guys for your suggestions. As per one of the replies I loosened all the lines thus allowing me to turn pump enough to line marks perfectly. Tractor now starts within a few revolutions and seems to run well. That 1/8inch misalignment of the timing marks certainly increased...- cliffswan
- Post #8
- Forum: John Deere
-
C
4020 diesel injector pump timing
Just rebuilt the engine on a JD4020 with the Roosa pump. Tractor starts and seems to run well once it starts, but it takes an excessive amount of cranking before it does start. Removed the rectangular cover over the timing marks view port and the two lines are offset about 1/8 of an inch with...- cliffswan
- Thread
- Replies: 7
- Forum: John Deere
-
C
Ford/Newholand TM125 brakes
Brakes on my TM125 quit working. Tractor has only got rear brakes. Checked brake fluid reservoir and it was empty. Filled with IRONGUARD brake oil as recommended by dealer. Bled brake Left side pressured up as expected. Could not get pressure on right side. Fluid dissapeared from reservoir... -
C
Case 580 backhoe shuttle shift rebuild problems
Thanks a whole bunch mEl. Just the information that I was hoping to get. I sometimes tend to overthink things instead of just going ahead and doing it. I really did not want to put it together, drive 120 miles, roll about in the snow for a while putting it back on the tractor then finding out...- cliffswan
- Post #1
- Forum: Case & David Brown
-
C
Case 580 backhoe shuttle shift rebuild problems
Sorry about missing the C. You tried to help and I appreciate the effort. Cliff- cliffswan
- Post #1
- Forum: Case & David Brown
-
C
Case 580 backhoe shuttle shift rebuild problems
The machine is a 580C. Present owner has had it for 5-6 years and used it quite a bit for clearing snow and some digging and it was working fine until the reverse quit working. It must have been assembled correctly for it to have worked that long. It just seems strange to have a snap ring...- cliffswan
- Post #1
- Forum: Case & David Brown
-
C
Case 580 backhoe shuttle shift rebuild problems
Backhoe would not move at more than a creep speed in forward and reverse according to lady who owns it. Her husband recently passed and she asked me to have a look at it. I removed oil sump and found partially clogged screen and chunks of fibrous material in bottom of pan. Oil was black...- cliffswan
- Thread
- Replies: 8
- Forum: Case & David Brown
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy