(800) 853-2651
SHOP NOW

Recent content by Clyde557NC

Yesterday's Tractor Forums
  1. rustred

    1755 cockshutt.

    i got this tractor running. there is a vibration in the hydraul power , as you can see it vibrating, and so does the starter vibrate. i was looking if anyone ran into this problem. dont think its a good idea to use it this way.
  2. L

    Pocket ledgers

    Can somebody tell me what years thes are for? 77 edition, has calender from both 1943 and 1944 on back cover, would be nice if it was from 1943 as I am a 43 model. 85 edition, has September to december of 1960. Complete 1961 calender and Jan to August of 62. 102 edition, calender same as above...
  3. T

    Case 430 Lift Arms Hydraulic Leak

    I have the 430 apart to order seals for the hydraulic piston. I was also told to order a shaft seal but what shaft and where? Thanks much, Trav
  4. 2

    OT: South Carolina guys...advice needed.

    Moving JD 550G dozer from West Virginia to Tenn., 545 miles. Hmh Logistics llc. Summerville SC made a low bid of $1400 with no down payment. Know if they're a dependable company? Seems awful cheap when the next low bid was $2000 from other companies. Lots of glowing reviews & a few really...
  5. onefarmer

    Playing with my toy.

    With the wet spring this field really struggled. Nearly drowned the wheat. So I tiling it. I'm really amazed at how much the ground had dried over just the last week. It went from moist to dry and hard. By the fence I had to give up it was digging so hard, it was mostly blue clay over there...
  6. D

    For the folks in eastern plains

    How is the weather between Dallas and Wichita?
  7. C

    Ford 861 Powermaster

    The pto shaft on my 861 has some weird gouges in it about 6 inches in, the only thing that is remotely near it at this point is the ring gear which has no marks on it. Does anyone know what could have caused this?
  8. D

    PTO grinds when handle is pulled

    PTO clutch doesn't totally disengage so the gears grind when I try putting pto in gear. I can put pto in gear before starting engine then hold clutch down while starting engine. Neither clutch slips under heavy load. I recall that two different adjustments are made on clutches on the bench...
  9. B

    900 Series Electrical issue

    I've got a 900 series with a serious electrical problem. I'm sure I have a ground somewhere, but I'm having trouble figuring out the wiring. My tractor has an ammeter. It does NOT have a Voltage Regulator, but does have a resistor block. I've tried to compare the wiring to the diagrams...
  10. A

    Some late summer pics

    Thought I would post some late summer pics I've taken over the last couple weeks. Hard to believe it's fall already. Got my hay put up, chopped the garden down, and have the 302 and UB washed and ready to go to the fair tomorrow. Also started painting the MM plow this evening.
  11. S

    NC or Bust - Iowa - Part 1

    Back to the trip...We were in a lot of snow at Albert Lea, MN, so headed south on I-35 to Des Moines, Iowa to try and drive out of it. Still day 1 and time for supper when we got there. We were now out of the crappy roads so felt we deserved a break for our efforts anyway. Stopped at a...
  12. B

    Wanted Dearborn 19-35 Road Maintainer to restore

    Hi I am looking for a Dearborn 19-35 Road Maintainer for my son and I to Restore. If you know of one for sale please contact me. Thank you Bill Blanchard 517-404-3416 [email protected]
  13. S

    Grounding outdoor outlets

    I'm installing an outdoor light on the opposite side of the patio from my house. I'd like to put an outdoor outlet there, too. The power to the new location will be supplied through a 12/2 w/ground underground cable from an existing outdoor light nearer the house. If I had been paying more...
  14. A

    Hold on Paul I am catching up to you!

    I am a proud owner of a Ford tractor! Open station and slightly used, good rubber but has some issues with the Hydralic system. It is a 9N.
  15. C

    how to clean diesel fuel injectors?

    Bought a New Holland 865 Skidsteer and want to go over it(fluids,filters,etc.). It is extremely difficult to try to crank when cold, so I want to see if anyone has any good ways of cleaning the injectors. Is there anything to pour into the fuel tank that really works or any other sure fire...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top