(800) 853-2651
SHOP NOW

Recent content by cole in mo

  1. C

    Tdc on John Deere 2550

    Mabey the marks are on the front pully, turn the engine by hand in the right direction, watching the #1 rocker arms. When the intake arm closes, turn the engine a little more, clean the front pully, looking for timing marks, same with the flywheel.
  2. C

    Allis d 17 lift arms wont lower

    On my 14, I have to pull the lift leaver all the way down, and if the lift arms are all the way up, put some down pressure on them.
  3. C

    Rain X wipers

    Sounds like you need to clean the windshield with some good glass cleaner, inside and out first.
  4. C

    Erickson V4 Ford Engine

  5. C

    Massey Ferguson 135

    If it's gas, might be a bad coil, if diesel, could be the head is bad in the inj pump.
  6. C

    Curious about air cooled engines

    Keeping an air cooled engine running at rated speed, the air intake shroud clean, and any build up of dirt and crud from the cyl fins, things like will keep one cool.
  7. C

    Creek find

    Looks some kinda gear box.
  8. C

    Hard starting diesel

  9. C

    pluged injector lines

    If plugged with old fuel, a small propane torch should burn it out, then use carb cleaner. If they are plugged with water and rust, a different set of lines would be in order.
  10. C

    Briggs and Straton engine troubles

    Most likley the timing gear went out, if nothing else is damaged, it's a simple fix.
  11. C

    Delco Remy starter 107448 (9C7 )

    Hook it to 6 volts, if it turns really really slow, it's 12 volt, if hooked to 12 volt and it turns really fast, it's 6 volt.
  12. C

    Need help with NH Super 68 hayliner

    On my 69-S the stationary knife isn't sharp, just a good square edge, and the book says to adjust to a 3/32 gap. To adjust the plunger knife you will need a manual, the plunger adjusts from the opposit side and takes some time doing it.
  13. C

    Tonights dear Barney

    12 ton in front of the trailer axel?
  14. C

    245 massy diesel, pto works, but no gears.

    Neighbor was brush hogging, a chain got wrapped up in the drive line and instantly killed the tractor. He said it will start, the pto spins, but it has no forward or reverse, could the trans input shaft have twisted off?
  15. C

    AC B Starting Problem

    Did you use the battery cables made for 6 volt systems, much bigger than 12 volt ones, also you might want to ground to something other than the steering post.
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top