(800) 853-2651
SHOP NOW

Recent content by colo iron

Yesterday's Tractor Forums
  1. C

    M F 35 Power steering

    It is the gears inside the pump that actually do the pumping
  2. C

    M F 35 Power steering

    I bought a MF 35 gas the power steering was not working when I bought it and it was out of fluid so I thought this was the problem but when that was not it I took it apart and found the gears was broke. I went to a salvage yard and there is none to be found. Is this a weak spot on these. What...
  3. C

    Ford 3600 3 pt lift

    yes I did mean the rear axle housing not the transmission and I did mean the flow control valve. Yes he has changed the oil twice and yes he has had the top cover off several times
  4. C

    Ford 3600 3 pt lift

    I have a 3600 ford tractor in the repair shop and the 3 pt will not lift the arms unless the RPM is raised up. He has replaced the pump, pressure relief valve, and control valve on the side of the transmission. When you move the black knob on the control valve it will not work. It is a gear pump...
  5. C

    3600 3 pt

    I have a 3600 Ford farm tractor. I was unable to control the 3 pt. it would either be up or down. I drained the oil and it looked like it had moisture in it so took the cover off and it showed rust and some of the parts would not move. I replaced the ones that need replace and freed the others...
  6. C

    cracked block

    I have a SO case with a cracked block behind the Carb. What methods have you used to repair or is it possible to repair
  7. C

    Death of son

    Sorry to hear about your loss of your son. I know what you are going thru I have lost both of my sons they were 32 & 46
  8. C

    C case

    I bought a C case tractor starts and runs good but the transmission is very noisy is this common or is there something I can do to reduce the noise. I put new 90w oil in the rear end. Thanks
  9. C

    SC going to Scrap

    Is the block in good condition with no cracks. Where in Kansas are you located
  10. C

    Looking for a tip from Case mechanics.

    I had the same problem and put the jacks on as you have done then I put screw jacks on the back side and hit it with a hammer and it popped loose with one or two hits
  11. C

    Showing our age

    I am 70 and when I ask my dad why he was keeping some thing he was say I can remember when I needed that and was unable to get it, so I still pickup pennys head or tails
  12. C

    Blacksmith Anvil

    How do I go about determining the age of a anvil. I found numbers on the base but unable to find a web site giving the age or year
  13. C

    Case K Combine

    My Dad's had a Waukeaha 4 cylinder Model FC 16 M I still have this engine off of his combine.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top