(800) 853-2651
SHOP NOW

Recent content by CountryCase

Yesterday's Tractor Forums
  1. C

    CC carb

    I am currently in need of a main nozzle for a carb on a CC. Im not sure if one out of a DC will work or not. If anyone has a extra one I could purchase it would be greatly appreciated.
  2. C

    7080 oil pressure

    Has good pressure every time I start it then falls off after just a minute or 2. Im not sure what pump it has. So it sounds like I need to drop the pan and check for a blown gasket at the pump?
  3. C

    7080 oil pressure

    About 4000 hrs on the engine. Always run strong. We dont over work it. I went out in the barn over winter to start it. Had to jump start it. In hindsight I didnt let it warm up enough before throttling it up so alternator would start charging. Thats when it lost oil pressure. I already had...
  4. C

    7080 oil pressure

    I have a 7080 that when you start it cold holds up around 60 lbs of oil pressure. It will run for maybe 2 minutes before going down to between 5 and 10 lbs. The oil is still cold. It runs smooth. No knocks. Just wondering if there is something I can try before going into deep on this and tearing...
  5. C

    Auxiliary hydraulic pump

    I am looking for a auxiliary hydraulic pump that was used on the 70 series tractors. I have located a pump but no gear that drives it off the cam gear. Just wondering if anyone has the pump with the gear or just the gear itself?
  6. C

    1175 frame rails

    I am looking for the frame rails that run along the side of the engine from transmission to the front end. Not all 1175s had them. My email is open if anyone has a set.
  7. C

    1175 frame rails

    Would anyone have a set for a 1175 in the southwest Indiana area ?
  8. C

    1175 frame rails

    Would anyone know if the frame rails from a 1370 will fit a 1175?
  9. C

    1175 puller

    I am having fire rings installed. I am lucky to have a person in the neighborhood that pulls on the national level. He pulls IH put knows engine building. Not worried about the engine. Just clutch an flywheel
  10. C

    1175 puller

    I have a few questions about setting up a 1175 for pulling. It will be running in a 3000 rpm class, 10 & 14 mph. We are swapping engines out for a 504. The 504 came out of a powershift tractor. Can I use that flywheel or the 451 flywheel or find a 504 flywheel out of a 8 speed tractor? Also the...
  11. C

    36 inch tires

    Does anyone have a set of 11.2 x36 or 12.4x36 tires in the south west Indiana are they would part with? This is for a tractor just to go to shows , no field work.
  12. C

    Dealer for Don

    Do you have this one?
  13. C

    8 speed reverse shaft

    I am the first to say I am not the sharpest tool in the shed, heck sometimes I don't even know if I belong in the shed. But I am trying to pull the reverse shaft out of the top plate on a 70 series 8 speed. I have the inner range shaft removed, the snap rings removed on the outside and the...
  14. C

    RE: 1175 transmission

    Well I figured out the issue with that transmission. I believe the picture tells all. Thank you to those who help with information.
  15. C

    1175 transmission

    Thank you for the information. I will be checking out everything you have said this week after I get the pressure washer after it for a minute.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top