(800) 853-2651
SHOP NOW

Recent content by CS (TX)

Yesterday's Tractor Forums
  1. C

    2n oil pump/front main cap to block torque question.

    Thanks TOH, that's good to hear because i had just gotten my oil pan buttoned back up today so I was worried i'd have to heave it off again just to re-torque that pump.
  2. C

    2n oil pump/front main cap to block torque question.

    Hello, I'm confused about how much torque the oil pump on my tractor needs. I've seen on this forum people saying that it should be 35-40 ft.lbs., but I'm unsure of this number as the spec for the main bearings is much higher than this. Essentially, i'm just trying to ask some of the more...
  3. C

    2N rear wheels

    Which rivets are you talking about? the way the wheels are mounted right now gives an extra 2" on one side. Is this a way that the wheels can be mounted to give more precise spacing?
  4. C

    2N rear wheels

    Hey everybody, I was spraying penetrating oil on my tractor's fender bolts when I noticed that my rear wheels were mounted differently. As you can see in the photos I attached one wheel is attached with the outer six nuts out, and the other is attached with the rivets pointing out. I was just...
  5. C

    2N lower oil pressure after head gasket job

    Hey everybody, I've been working on a 44' 2N that sat for about 15 years. I got it running a few weeks ago and decided that it needed to have its head gasket replaced after seeing the melted chocolate ice cream that was in the crankcase. Before I replaced it it would show 20 lbs on the gauge...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top