(800) 853-2651
SHOP NOW

Recent content by cthanse

Yesterday's Tractor Forums
  1. C

    ford jubliee

    will do what you say, thanks ct hanse
  2. C

    ford jubliee

    appericate your help with my problem, will try your ideas
  3. C

    ford jubliee

    thanks for your reply , ct hanse
  4. C

    ford jubliee

    I have done all of these suggestions, cthanse
  5. C

    ford jubliee

    I took carb off complety & cleaned with carb ' cleaner & comp' air' thanks for your reply, ct hanse
  6. C

    ford jubliee

    carb bowl seems to be full, appericate your info'
  7. C

    ford jubliee

    i'll try that , thanks for your input
  8. C

    ford jubliee

    points were replaced and adjusted , thanks for your reply
  9. C

    ford jubliee

    my ford jubilee, will start, after much cranking, and run for about 30 sec', then quits,. I've replaced plugs, condenser, wires, coil , cleaned&adjusted carb'checked static timing. nothing has helped, anyone have any ideas? thanks ,ct hanse
  10. C

    Tricks for removing rear axle seals on Ford NAA.

    you can get a seal puller from pep boys or harbor frgt' to pull seals out.
  11. C

    rear axle leak ford jubliee

    thanks for the link to john's site I 've looked at it, before I started replacing seals, he is very good about details. thanks again for your reply , cthanse
  12. C

    rear axle leak ford jubliee

    I don't think I forgot any of seals, but will check when I pull it off , thanks for your input, chanse
  13. C

    rear axle leak ford jubliee

    have replaced oil seals on both rear axles appx'10 hrs ago. rt rear axle is leaking oil around axle nut. I put blue rtv sealer on all mating parts. could axle or hub be worn, causing leak? thanks for any help
  14. C

    NAA power steering (6-800)

    how much for power steering parts?
  15. C

    stablizer bars

    i have one sixty A-c , very good condition, however it looks like previous owner weled a piece of rebar to ends of stabilizer bars you can adjust length, but you have to remove & reinstall bar. question is how was orginal bar made? ie; did it have a turnbuckle in line? thanks for any...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top