(800) 853-2651
SHOP NOW

Recent content by culebrapr

Yesterday's Tractor Forums
  1. D

    planning a trip to glacier park in montana from missouri

    thinking of using I90, is there a better route or is there any ongoing construction to look out for? is I 94 a better road? Any favorite spots to check out? looking to travel about 8 to 10 hrs a day from central mo best places to stay overnight? thanks for any input
  2. K

    cletrac ag6

    ok bought the ag6 loading it on trailer carb started leaking fuel again its a tillotsun carb i would like to replace with a ms or a zenith how can i cross refrence as to find correct carb? thanks karl
  3. G

    4010 power steering doesn't work

    My son was mowing with my 4010 and bush hog and was quitting for day and drove to the barn to blow off the trash. When finished the power steering would only move the front wheels a little each way. He checked the hydraulic fluid and it was low. Filled it up and there was no difference in the...
  4. B

    Help identifying an old Ingersoll Rand Trailer Compressor

    I have a 1952 vane type trailer mounted compressor powered by what appears to be an F140 engine [F140A3107 is the head casting]. The engine tag is unreadable and there is no frame plate. The tank plate indicates it is 1952. The compressor end has a casting # of 105CR1256. A decal on...
  5. wjytexas

    Happy Easter

    No tractors but kinda rural-ish. From the very early 1900's
  6. C

    Ford 555b brakes

    I purchased a Ford 555b backhoe which has several systems needing refurbuishing. I have taken out the parts used for the brakes. I am now ready to reinstall these parts however I can not remember how they are installed on the brake control rod and the service manual is not very clear. Does...
  7. C

    Brake adjustment

    I have a Ford 555b which needed to have the brakes adjusted however the large 2.5 inch washers were bent and the rod seal needed to be replaced. After replacing the seals I can not figure out how the other parts fit on the brake rod. The drawing on the 550 manual just doesn't look the same as...
  8. C

    Wiring on a Ford 555B backhoe

    Thank you for the quick response. I saved the picture however when I print it it's too blurry to understand, could you maybe sent the file to my email address [email protected] ? Thanks again.
  9. C

    Wiring on a Ford 555B backhoe

    I am rebuilding the harness on a Ford 555B backhoe but the wiring schematics I got from the Ford 550 Service Manual does not match the color codes on the 555B model. Therfore I am not sure what wires go where on the headlamps or starter switch. Does anyone have the correct schematic?
  10. C

    Return to Dig

    Oops, the model is a Ford 555b
  11. C

    Return to Dig

    Does anyone have a schematic for the"return for dig" system on a Ford 555b?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top