(800) 853-2651
SHOP NOW

Recent content by dabot

Yesterday's Tractor Forums
  1. D

    What's up with this style of hub/lug nuts?

    Nice looking 1555 utility!
  2. D

    Oliver 550 1966 throttle shaft on carbuerator needs replaced MS TSX811

    Sorry. I found it for sale on this website.
  3. D

    Oliver 550 1966 throttle shaft on carbuerator needs replaced MS TSX811

    The throttle shaft on my 1966 Oliver 550 carb is shot. How can I get a new one? It is a Marvel Sheb TSX 811.
  4. D

    Oliver 550 carburetor options

    I do not know the number but it is original on a 1958 Oliver 550. Text me your number and I will give it to him to contact you. Duane 8126396536.
  5. D

    Oliver 550 carburetor options

    The 58 model had a smaller carb like the super 55. I have a buddy parting a 58 out if you cant find one. It is a Marvel Schebler.
  6. D

    super 55 pto

    Yes, there is two allen screws holding the clutch pack. The short one is to lock the longer one. Hard to get to slide off with removing just one. Don't ask how I know.
  7. D

    Oliver 550 front axle pin

    Any suggestions on how to drive out the front axle pivot pin on a Oliver 550? It appears it has to come forward. Kent, I am sure you have done one or two.
  8. D

    Question for Dieseltech or others

    I tried a new fitting with the ball inside and it did a little better but continued to die. I punched the ball out of the old one, put it back in and all is well. I was told you can not get one with a bigger orifice and check ball. I have to say, I almost lost my religion on this ordeal. Thanks...
  9. D

    Question for Dieseltech or others

    My tank was cleaned by a professional. Good flow to prime. Started right up then died. I loosened the cover on the pump and it would prevent it from dying. I removed all the return lines and blew air through them and the T's. Fired right up. Went to wash my hands and it died. I am at a loss. I...
  10. D

    Question for Dieseltech or others

    Thank you Dieseltech. The tank is out of the tractor and going to be cleaned out. I will check the filter upon bleeding system.
  11. D

    Question for Dieseltech or others

    I have a rebuilt 1555 diesel. Pump was gone through by professional that is now retired about 8 years ago. It would ocassionally die from fuel starvation. Found a plastic gas jug cap floating in tank that I assumed got pulled down on Strainer assembly. Thought problem was fixed. After sitting...
  12. D

    carburetor

    I have a 1650 I purchased for the fenders. Guess I will part the rest out.I do not know if it will work. I can get the TSX number off of it. Also has a replaced Mallory distributor. Duane 812-six three nine 6536.
  13. D

    Gresen 2 spool valve. Oliver power beyond

    It is a model 2702. It came off an Oliver 550. There was a plug in one of the cylinder ports and an exhaust hose on the bottom.That is the cylinder port that I can't blow air through. I plugged the bottom and put an elbow where the plug was. My number is 812-639-6536. Thanks again John!
  14. D

    Gresen 2 spool valve. Oliver power beyond

    I'm going power beyond on my 1550 Oliver. I have a open center two spool valve off an old Oliver. On the bucket tilt spool, when I blow air in the inlet air only comes out one of the openings with the handle pulled or pushed but nothing with the handle the other direction. The lift ports work...
  15. D

    How can I tell if my 1550 has the "high speed reare

    My 1550 & 1555 utilities have a high speed. That code is -506.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top