(800) 853-2651
SHOP NOW

Recent content by Dale Logerquist

Yesterday's Tractor Forums
  1. D

    Follow-up , 9n converted solenoid problem

    This tractor has been converted some time ago. Bought it that way. It just has the key start switch no push switch at all.
  2. D

    Follow-up , 9n converted solenoid problem

    Yes - that means to me the solenoid it bad. right? Shouldn't get power through the solenoid if not open.
  3. D

    Follow-up , 9n converted solenoid problem

    Hello, I just wanted to follow up with it issues of a solenoid problem I had yesterday. With all of your help I had finally decided to take off the new solenoid and put it on a meter. However I ended up droping it and cracked the housing open to discover the larger post was turned and was...
  4. D

    9n converted solenoid problem

    Thanks you for your pictures they are really worth a thousand words. I see that the little jumper wire was attached to the main post from the battery. Thanks again. Dale Will let you know if it didn't work. Happy Holidays
  5. D

    9n converted solenoid problem

    Jack - Thanks for your post but please give me more information on what is missing or how this set up is bad. I purchased the tractor this way and have always started it in the nutral position. However if there is a safer way please let me know Dale
  6. D

    9n converted solenoid problem

    Thanks for the comments I thought it may have something to do with that small gounded wire. This tractor has no push button - Just turn the key and start. The little wire that I grounded was used as a jumper - if not to ground to what other post and does it matter what post the leads are...
  7. D

    9n converted solenoid problem

    Thanks for the comments I thought it may have something to do with that small gounded wire. This tractor has no push button - Just turn the key and start. The little wire that I gournded was used as a jumper - if not to ground to what other post
  8. D

    9n converted solenoid problem

    I hope someone can point me in the right direction. I have a 9n ford that has been converted some time ago to 12v. For some reason the solenoid post had melted and caused the tractor not to start. I could jump across the post and start the tractor. I decided I needed to replace the solenoid...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top