(800) 853-2651
SHOP NOW

Recent content by Dan Wittek

Yesterday's Tractor Forums
  1. D

    8n toe in problem

    Hey guys...looking for a little more help....just finishing a fairly extensive restoration on my 47 8N. New drag links installed this weekend as the originals were bent beyond repair. Now I have a toe out condition and the ends are adjusted all the way in! Front axel is at medium width, so...
  2. D

    Main shaft and countershaft seals

    Thanks Bob, this helps. Yes, there are signs of leakage there. Otherwise, I would certainly leave it! Appreciate the help!
  3. D

    Main shaft and countershaft seals

    Hi Bob, Thanks for the reply. Maybe I should have clarified between seal and gasket. The diagram you provided, (thanks, by the way!) does show a gasket (16) on the countershaft. If the input shaft is that easy, then I would assume the countershaft is as well, but my concern is that I remove...
  4. D

    Main shaft and countershaft seals

    Hey all...looking for a little assistance. Almost done with a fairly extensive 8n restoration. Motor rebuild, clutch, new steering and paint is done. Tranny and hydrolics worked before, so i didn"t plan to open them up; however, I would like to replace the seals for the main and counter...
  5. D

    H trans input and countershaft seal

    I'll try loading this picture again.
  6. D

    H trans input and countershaft seal

    Hey guys. Any ideas on how to remove the transmission input yolk so I can access the seal? I have tried pry bars and tapping on the yolk with a hammer. No luck yet. Also... the countershaft seal is leaking. No bolt in the center of the countershaft yolk. How does it remove? Sorry if these...
  7. D

    1940 (?) H Transmission input seal

    Hi Wayne, THANKS for the reply. You have no idea how happy I am to hear that. I ordered the seals that I believe I need and plan to dig into this on Wednesday. I"ll send you a message if I run into problems! Where are you in Minnesota? I am from Minnesota but now reside in Wisconsin just...
  8. D

    1940 (?) H Transmission input seal

    Hello. I recently purchased this old H tractor. It has a pretty good leak in the front transmission seal. Do I need to split the tractor to do this or can it be done from up top? I am very mechanical, but don't really know tractors. I bought a service manual, but it is not that specific. I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top