Recent content by Daniel Vader

  1. D

    Farmall 504 water pump (again)

    so i am trying to find a water pump for my Farmall 504. I ordered one from Yesterday Tractor and it says it fits but it doesn’t. My pump says part number 375736R1. The closest I can find says 375736R91. What do I need to do here?
  2. D

    Farmall 504 water pump

    Rustred — spell check!!!
  3. D

    Farmall 504 water pump

    Ok. I’ve ordered a new water pump. Rusted and Kevin M - thanks for your help!!
  4. D

    Farmall 504 water pump

    Yes. Fan is attached to pump.
  5. D

    Farmall 504 water pump

    My fan is rattling against the fan shroud on the radiator. If I wiggle the fan back and forth it has obvious play in what I assume is the bearing. Is this a separate thing from the water pump? What do I have to replace to remedy this?? Thanks in advance.
  6. D

    Bottom screw on Zenith carb missing

    When I went to start up my Farmall 504 with a Zenith carb this spring I found the screw on the bottom of the carburetor was missing. All the gas was pouring out through the bottom of the bowl where the screw was supposed to be. Is this just a drain screw? What size is it and where can I get...
  7. D

    Farmall 504 hydraulic problem

    To clarify it is the load control linkage that has come undone. Is there something I can do under the seat so that I can still use my position control to get my 3 point to function.
  8. D

    Farmall 504 hydraulic problem

    I have a gas 504. The 3 point hitch stopped working. The linkage for the outside quadrant control for the 3 point has fallen apart and become disconnected inside the hydraulic unit under the seat. I have no idea how it goes back together. Can I jam one of the valves in the underseat unit so...
  9. D

    Farmall 504 clutch

    When in 5th gear at a dead stop the tractor just sits there. It also does that in other gears under a heavy load unless I pull on the torque amplifier. I think I need a new clutch. What is involved and what should that cost?
  10. D

    Farmall 504 clutch

    I have an early 60's 504 that someone gave me. It runs good and has good hydraulics but it you put it in high gear and let out the clutch it just sits there. With a load on in lower gears it won't move unless I pull on the torque amplifier. Do I need a new clutch and how much should that cost?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top