(800) 853-2651
SHOP NOW

Recent content by Dapollack36

Yesterday's Tractor Forums
  1. D

    mf 65 rims

    Any pictures of those rims?
  2. D

    MF245 fuel pump/lines

    Ok, I got new olives, can anyone explain the sequence that they are installed? Ie. Fuel pump, olive, flared fuel line and tighten or Is It fuel pump, flared fuel line then olive and tighten?
  3. D

    MF245 fuel pump/lines

    I removed my fuel pump on my Perkins and man were the line tough to remove, there s a o ring in each port where the fuel lines connect. My question, anyone know what type of o rings are used to replace the old ones or can I utilize these brass fittings and run rubber fuel lines? Thank you
  4. D

    MF 245 remote

    That is awesome, thank you for the help. Now another question, my hay cutter only has 1 hyd line, which port does it plug into?
  5. D

    MF 255 horizontal exhaust converted to vertical

    I hate to ask but can you get a close up of those front tires and rims, I?m looking for that set up on my 245. Thank you
  6. D

    MF 245 remote

    Good morning, I m currently in the process of putting my older 245 back to work. The issue I m having is I wanna run a hay cutter out back that needs one remote. I attached pictures that show what I currently have, there s a lever on the part that s mounted in front of the seat. I just need to...
  7. D

    Ford 555 brakes

    I assume that linkage you're speaking of is internal?
  8. D

    Ford 555 brakes

    Would a service manual walk me through any internal repairs if necessary?
  9. D

    Ford 555 brakes

    In yalls opinion where and how should I troubleshoot this issue?
  10. D

    Ford 555 brakes

    I appreciate the assistance and if it is worse case scenario is it possible for me to use the machine around our ranch without doing any internal damage?
  11. D

    Ford 555 brakes

    Yes sir I was applying the brakes to release the parking brake and they "popped" and went to the floor
  12. D

    Ford 555 brakes

    Yes sir I tried both peddles and they both go to the floor, any suggestions?
  13. D

    Ford 555 brakes

    It's a 1978 machine if that helps
  14. D

    Ford 555 brakes

    Stupid question but what do you mean by open it up?
  15. D

    Ford 555 brakes

    Sir The pedals return to the up position once I push on them but when I do apply the brakes the pedals go to the floor and does not stop the tractor at all, hopefully this clears it up a little
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top