Recent content by Darald

  1. D

    Hours on M

    My dad bought a SMD in August of 52, it hasn't been used for 30 years and it sits with over 17000 hours. One overhaul, at 6000 hours, trans and rear end bearings, engine sleeves and pistons. For a few years it was the only tractor on 4/4's and a couple hundred cows to put winter feed up for...
  2. D

    Re: IH Windbreaker F 806 D

    I couldn't email back to you, mail me again with your e mail. thanks Darald
  3. D

    Re: IH Windbreaker F 806 D

    How much and where are you located, send me an email...Darald
  4. D

    1947 Cub I think

    What you have is a cub low boy, 1956 or 57.
  5. D

    300 paint job

    Only the rear rims were silver, the fronts disk was all red on the 300 U. Darald
  6. D

    Alameite and IH

    Does anyone know if there was a connection between IH and Alemite grease guns. My dad had several Alemite (not sure of spelling) grease guns from the 40's and early 50's that came with IH machines. Most of them were a pump type, where you place the fitting on the nipple and pushed up and down...
  7. D

    660 starter

    Still working on my 660 starter. From which end of the starter do we view the rotation. Shop says the 660 calls for a CCW starter and that is the direction that it turns viewed from the field end and that one turns the engine the wrong way. What has to be changed, the armature for sure...
  8. D

    Power steering on a 1800

    345 cu in.
  9. D

    Darald 660

    I took the starter back to the starter shop a couple of weeks ago and have not been back to get it. It was turning the wrong way. Thanks for the concern...Darald
  10. D

    820 V 4

    No I haven't, would that keep the ignition from working?
  11. D

    820 V 4

    For 2 days I have been trying to get 2/4 points to fire. Have bought new coils, poi ts, and condensor ...2 sets. I have switched items from side to side with the same result. The engine will run on 1 and 3. Sometimes it will speed up like its trying to fire on 2/4. Do I have to buy a rebuilt...
  12. D

    Darald and 660

    Here we go, she turns backwards. Now should I change the polarity of the tractor and re do the regulator to make it a positive ground, or just call it a day and return to the starter shop...
  13. D

    Darald and 660

    I have been away from it for a few days, but the next thing to check is the starter rotation, if I can I will check it tomorrow, and let you know. I am heading back to the starter repair place on Monday anyhow.
  14. D

    660 won't start

    Bought it last year, it started and ran good. This spring it broke the starter shaft, new starter, turns good etc. The glow plugs seem to work, when pulling if the plugs have been lit, it starts immediately, running clean, it will even start if the glow plugs haven't been lit, but burps and...
  15. D

    660 won't start

    New battery, cables and starter, turns over good, but will not pump fuel, no smoke. Pull it 15 feet and its running, it immediately starts smoking when being pulled. Got me not thinking straight. Thanks for any suggestions...Darald
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top