(800) 853-2651
SHOP NOW

Recent content by David Adams

Yesterday's Tractor Forums
  1. D

    Ford 4000 Hydraulics

    Hi, thanks for replying I have tried the middle plunger both fully in & out, one way powers the external service - in this case it was the loader block. - Are you saying put the plunger in the middle & the short lever on the right in the centre? PS, I will be away for a week, so will respond...
  2. D

    Ford 4000 Hydraulics

    Hi all, In relation to the last image (the rear of the reactor) there loader is powered by the outlet / tipping pipe at the rear
  3. D

    Ford 4000 Hydraulics

  4. D

    Ford 4000 Hydraulics

    Heres the images of the loader valve block / assembly ATB Dave
  5. D

    Ford 4000 Hydraulics

    Hi, & thanks for responding The tractor is a Force - 1973 3 cylinder ford 4000 Diesel The return pipe is the return line from the loader remote valves. Its gotten me beat ATB Dave
  6. D

    Ford 4000 Hydraulics

    Hi all, Ive bought a Ford 4000 with a fitted Farmhand loader - this works well. I removed the loader & proceeded to try the hydraulic arms, there is very little movement on the quadrant lever, but when I force it forward (about 1/2) the arms drop slowly, but when I let go the arms lift again...
  7. D

    Ford 3000 fuel pump

    I've had this ford 3000 for a number of years and it has always been a pig to start, so far I have tried the following: new injectors, fitted a heater plug into the manifold, new battery & leads Now the diesel pump has stopped pumping fuel hence it won't start. The engine runs well without any...
  8. D

    Ford 3000 brake linkage binding / not engaging

    Thanks Bern for the reply, Ive previously had the wheels & hubs off & they were fine with no oil contamination evident. I have replaced the springs to enable the pedals to return to the top position after use & adjusted the brake rod to take up any slack in the system. The brake bar that goes...
  9. D

    Ford 3000 brake linkage binding / not engaging

    Ford 3000 brake linkage seems to bind up, the foot operation dosen't seem to create enough movement to activate the drum brakes. Is this down to wear & tare with some kind of bushing or something ? ATB Dave
  10. D

    Ford 3000 wiring diagram (showing glow plug wiring)

    Its A Force, therefore after 1965 Regards Dave
  11. D

    Ford 3000 wiring diagram (showing glow plug wiring)

    Hi all, I'm still looking for a wiring diagram for my force diesel Ford 3000, with the glow plug included. Any help would be appreciated. Dave
  12. D

    Ford 3000 inlet manifold heater install / wiring diagram

    I have a Diesel Ford 3000 (force), The tractor needs ether to start every time it's started from cold. I have ordered a heater plug that will screw into the blank on the inlet manifold, copper pipe & an ignition that will allow the heater to be operated. I am intending to take the Diesel supply...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top