(800) 853-2651
SHOP NOW

Recent content by dieselbob

Yesterday's Tractor Forums
  1. D

    Flow control on Magnum tractor

    Doses anyone make a kit for the hydraulic flow control on the remotes on the Case IH 7120 Magnum tractor? It has the factory cable adjuster on it and not a good design to begin with. Bob
  2. D

    Brake lights

    I found the switch it’s on the floor behind the seat on the drivers side, I located 2 switches replaced one that I thought was bad but didn’t help possibly bad replacement it had 3 terminals on it one ignition other two brake lights on trailer one of the trailer wires is energized when the park...
  3. D

    Brake lights

    That’s what I have been doing following air lines looking for an air switch or air manifold that could have the brake light switch in it. I do have wiring diagram I’m going to test some relays tomorrow also, it would be nice to find the switch location and test that. Thanks for everyone’s input...
  4. D

    Brake lights

    Yes it has air brakes. I will look closer tomorrow. I have looked on the fire wall both sides took the dash apart looked at the foot valve it’s mounted under the floor
  5. D

    Brake lights

    I know it’s not a tractor question necessarily but I working on one of my grain trucks getting ready for harvest. This is on a 1998 Ford semi tractor it looks like the Sterling model, It has brake lights on the tractor but not the trailer, when the park brake is set the stoplights are on like...
  6. D

    1080 main hydraulic pump

    Did you take out the control valve when you rebuilt the pump? it sits in the pump housing it obsoletes back and forth when running to raise and lower hitch the valve must move in and out many times these become stuck
  7. D

    1080 main hydraulic pump

    How do I remove the main valve on the main hyd pump? I have an IT manual it said there is an internal snap ring not sure where that is. Also the pressure valve? Is it ok to heat the main pressure valve a little so it can be unscrewed? This is a project tractor that I bought the three point...
  8. D

    1080 questions

    I bought a 1080 this summer and started to work on it. Two issues that I knew about are the three point do not raise and the pto slips, the thing I noticed on three point is the linkage coming from the top cover was on the front side of the roller that is on the pump, isn’t it supposed to be on...
  9. D

    Farmall 666 Hydraulic Pump

    Another possibility is the hose in the rear end is bad, to get to it you remove the cover for the third arm and look in the hose goes from the top cover to the pickup tube in the bottom of the transmission it is a common problem when they start to suck air
  10. D

    M602 PTO lever

    I had one like that on a M670, I had to remove the top cover to get at the pto clutch it was all rusted up from sitting to long, had to loosen up the ring and start cleaning it up then readjust it when clean
  11. D

    governor spring

    Thank you for the information, after harvest I will have time to work on this project again. Thanks Bob
  12. D

    governor spring

    I'm using an engine from an E gleaner combine in a project and need to have a higher RPM from the engine need around 2500 rpm or maybe even 2800 it would be for short time periods and then just idle, can this be done with a gov spring from a 170 or D17? What other modifications would be needed...
  13. D

    What to use to clean out old diesel fuel lines?

    I use E85 let it se over night works like a dream.
  14. D

    1070 transmission

    Thanks for all the advice. Tractor is by Granite Falls, MN
  15. D

    1070 transmission

    There is a 1070 coming up at auction, it says it doesnt move in second gear this is a power shift tractor. What are the possible causes for this issue
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top