(800) 853-2651
SHOP NOW

Recent content by Don Freytag

Yesterday's Tractor Forums
  1. D

    Full throttle spit and sputter.

    I remove the sediment bowl again and cleaned very little junk from that, I blew out the screen inside the carb from the down stream side and it is clean also. I am going to try and run it again this morning. LOL After a good nights sleep and a couple shots I might be a little less likely to...
  2. D

    Full throttle spit and sputter.

    Ok...took the carb back off took it apart and put a small copper wire through the passages and blew it all out again. Put it all back together rechecked the timing, governor, idle mixture and gave it some throttle. Guess what! SOS still runs like crap at full throttle :o( .
  3. D

    Full throttle spit and sputter.

    I finally got my clutch pieces and got the tractor back together. I added fuel and removed the bolt from the bottom of the bowl. I got nasty junk so I dismantled the carb and cleaned it out good. Went and got a carb kit and put it all back together after cleaning and blowing through all the...
  4. D

    TO 35 Cltch Part numbers Help!

    You were correct on the spring, lever, and adjuster screws as the part numbers were correct. Do you by chance have the number on that pin that goes through the lever? Then I think I'm done with my numbers search for now! Thanks so much for your reply!
  5. D

    TO 35 Cltch Part numbers Help!

    Ok so I went to pick up parts today. I got the other two springs Part number 181125M1 and as far as the levers on the clutch itself. These were part number 1753750M1 I only needed one but they were sent as a set of three and I had to buy all of em!. The pin that goes through the lever they didnt...
  6. D

    TO 35 Cltch Part numbers Help!

    CLUTCH PART NUMERS needed
  7. D

    TO 35 Cltch Part numbers Help!

    While changing my two stage clutch on my 55 TO 35 deluxe I noticed that on one of the 3 clutch relese arm/ levers that there was a small crack in the part where the pivoting adjustment screw head rides. I bought 3 new adjuster screws and ordered 3 new springs and when the parts came in I was...
  8. D

    TO35 Front transmission leak

    Took the PTO shaft out per Big Dean. (It was an old style that the doesnt have to come out the back of the transmission) The snap rings were a pain with out a STRONG set of snap ring pliers, I ground dorn some good needle nose for the job after fighting it for a while. I got the front housing...
  9. D

    TO35 Front transmission leak

    oops its early I meant Big DEAN
  10. D

    TO35 Front transmission leak

    Thanks you are right! Big Cean also had the answer for me,
  11. D

    TO35 Front transmission leak

    I have the tractor split. The 4 bolts out of the front input housing. I would have thought it would pull off. It gets tight when trying to pull it off to replace the seals. Is there a trick to removing the housing or is it just the old seals holding it on? It comes out about 1/4 inch and then...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top