-
D
135 Massey Valve Guides
Thanks. Maybe I can just measure the old ones and just shoot for that depth with calipers.- Donald11
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
D
135 Massey Valve Guides
Anyone....another option please....- Donald11
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
D
135 Massey Valve Guides
Hello,I am needing help on replacing the valve guides on a Z145, The manual shows a press tool (Driver OTC-FT_52) and two bushing to set the depth. I cannot seem to find these tools on the net. Does anyone know of a source for these tools. Thanks for any help. Donald...- Donald11
- Thread
- Replies: 3
- Forum: Massey-Harris & Massey Ferguson
-
D
Gravely 8122 transmission noise
Yea my old 430 commercial rider has a dip stick. I never start it without checking it. The darned 8122 has a fill plug, with no dip stick. does any know if you can add a dip stick that would really help.- Donald11
- Post #1
- Forum: Garden Tractors
-
D
Gravely 8122 transmission noise
Hello, I have a bearing howling type of noise, it seems to be coming right from behind the engine (kohler), with the pto off and not turning. It is loud with just the engine idling and sitting still. If any of the board members could maybe point me in the right direction as to which bearing may...- Donald11
- Thread
- Replies: 4
- Forum: Garden Tractors
-
D
Input Shaft Seal
After reading some older post seems Masseynut Australia has some info on this subject is he still around or does any know of a contact for him. Thanks....- Donald11
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
D
Input Shaft Seal
Man, I'm stuck. I split my 135 massey to replace the input shaft seals. Then i find out that you have to also split the transmission to get to the input shaft retainer out. My question is how far do you need to slide the trans out to drive back the PTO shaft. I was thinking of putting long bolts...- Donald11
- Thread
- Replies: 1
- Forum: Massey-Harris & Massey Ferguson
-
D
135 Leaking oil
Its definately transmission fluid... Thanks- Donald11
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
D
135 Leaking oil
Hello all, I just purchased my first tractor a gas 135 massey, I have oil leaking from where the brake pedal shaft gos into the tractor, can anyone tell me why oil might be leaking from there. Thanks for any replies...- Donald11
- Thread
- Replies: 2
- Forum: Massey-Harris & Massey Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy