(800) 853-2651
SHOP NOW

Recent content by donner49-HT

Yesterday's Tractor Forums
  1. D

    Tractor keeps eating steering

    could be the spindle bearings are frozen to the spindle causing it to turn hard. i had the same problem on a kubota. i changed the steering gearbox twice and then decided to check the bearings on the front. disconnecting the tie rods while wheels were off ground. turned wheels by hand and...
  2. D

    Jd B again

    I'm sure Wickams B's or B run great, So tell me what is needed to get more hp then, I'm at 52 (.176 hp /cube) with 294 cubes. Just bought a block from a friend that I could have bored to get me up to 5.450 from my 5.080 now, how much more power would be expected in your eyes from that alone...
  3. A

    550 carb- acting up need choke half out

    550 carb. acting up wont stay running unless choke is about half out. got good fuel supply no known intake leaks. carb was new rebuilt about a year ago. any help appreciated.
  4. E

    Front axle support input

    I need some good advice. The front axle support on my 850 needs help in the worst way. The question I have is: should I buy the repair kit from Pete Pfieffer or should I try to find a rebuilt support assembly? The tractor has a heavy Lord loader on it, but I believe it has lasted over 50 years...
  5. H

    IH 615

    Hello everyone. I just bought a nice 615 combine with a 10 foot grain head and was thinking about looking for a corn head. If anyone had any info. or a web site i could go to and find the info on what modle heads and their size that fit it would be helpful. thanks very much and have a good day.
  6. A

    beavertail on stepdeck

    Does anyone manufacture a weld on, or a bolt on, beavertail for a 48 foot stepdeck? One can use a dock someplaces but not everywhere you go (espcially with vintage stuff) do they have a dock. Any ideas, manufactures or plans, will be helpful. Thanks...Darald
  7. A

    shovels for a springtooth harrow

    I can't find anyone on the net that has the shovels I am looking for. 2'wide, 6-8"long, with 2 mounting holes on 1" centers. The originals were pointed on both ends so you could swap them over. The spring tooth is a 2 section IHC with rear smoothing bars. Thanks
  8. A

    5000 air intake pipe gas engine

    I need the pipe between the carburator and the air-cleaner for a Ford 5000 GAS. Thanks!ph.559-351-9272.Fresno,CA.
  9. A

    skid loadere bucket

    wanted manure bucket for a 330 mustang skid loader 507-438-9707
  10. J

    farmall cultivators

    I see in NV farmer post (finally Super a pictures) cultivators,is this a common set, are there other styles. I live in Nova Scotia "Canada" lots of Farmalls but cultivators are hard to come by. Have some people looking but no luck so far. I want to plant asparagus. Thanks Kerry
  11. A

    O/T: '88 Cherokee emissions timer

    How do I reset the emissions maintenance timer on an '88 Cherokee(4.0 L, auto, 4x4)? Thanks, Anthony
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top