-
-
2
Re: MF202 power steering column seal...final chapter
I hope you will post more about the new system as having a 204 project on the burner and a spare 35 PS system I couldn't get to cooperate. Are the spool valves the same between the 35 and the 202? I know about the 35 having a piston while the 202 has the hydraulic cylinders.- 2tractors
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
D
861 Steering
Thanks soundguy. Just heading out of town for Christmas but will check when I get back in a few days and let you know. Merry Christmas!!! -
D
#1 cylinder not firing on 861???
Thanks for the info. I took the advise of the majority and got a new set of plugs and wires from NH implement. Changed the number one plug and it came right around. Changed the wires too for good measure. Thanks again....Don -
D
#1 cylinder not firing on 861???
Thanks, I hope to be able to get some time this weekend to check it out. Will start with replacing the plug. Hopefully it's that simple as I know I won't have the time or the heated shop to get her fixed up if it's something more serious... at least not before the snow starts flying in NW Iowa. -
D
#1 cylinder not firing on 861???
Was just dry fitting the heat house on the 861 a couple nights ago and noticed that it sounded a bit rough. Kinda sputtering and missing so last night I pulled the coil wire and bumped it over, nice blue flash. So I had it running and started pulling plug wires...pulled the #1 cylinder and the... -
D
Tractor barely runs with lights on
Thanks for the info guys, I appreciate you looking past the mess of this post and responding. I"ll address the tractor issue first.....I checked all my connections last night and they are good. Grounds are good. Next I checked volts on the battery when tractor is not running and running at idle... -
D
Tractor barely runs with lights on
Soundguy, Please feel free to refrain from responding to any of my posts in the future. As a rookie in the tractor world, some of the things that you assume are common knowledge are not to someone of my meager experience. It is however obvious to me by your 28,000+ posts that you enjoy watching... -
D
Tractor barely runs with lights on
I just got all of my new lights wire up (two head lights up front, two flashers and an implement light in the rear.) If the tractor is running and I flip the toggle for the headlights/flashers, the oil pressure drops a couple pounds and the tractor runs a little rougher, kinda stumbles a bit... -
D
Flasher for 861???
Wiring new lights on 861. All old lights had bad wiring so I tore it all out and wired for new. I installed two flasher lights on the rear along with an implement light and new headlights up front. Turned the switch for headlights and rear flashers and they all come on but the rears don't flash... -
D
Ford Loader ID???
Thanks for the response...would that be with cylinders fully extended or contracted?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy