-
D
8640 exhaust relocating
Buy a newer tractor!- Dr Gago
- Post #1
- Forum: Farmall, International & McCormick
-
D
Has anyone shipped a tractor drawbar bare, not boxed?
Yap, UPS, but I wraped tape around the shipping address, and holes in the drawbar.- Dr Gago
- Post #1
- Forum: Tractor & Farm Talk
-
D
top 3 best farm/ranch loader tractors of all time?
5500, 1 reverser, 2 loaders, 3 sets of tires, over 10,000 hours. Starts up ready to go every day.- Dr Gago
- Post #1
- Forum: John Deere
-
D
Polk's Auction last Week
https://www.proxibid.com/asp/Catalog.asp?aid=46218- Dr Gago
- Post #1
- Forum: John Deere
-
D
Best way to lift a JD B with winch truck to load
just hook it and lift!- Dr Gago
- Post #1
- Forum: John Deere
-
D
4430 head gasket
Go to 165 lbs and run it! never had a problem yet.- Dr Gago
- Post #1
- Forum: John Deere
-
D
JD 4050[466or 329]which is better
414 is a gutless wonder in my 7600. wished I bought a 7700, or 7800. it's a big tractor with a small engine, no lugging, just a good thing it has a power-quad. reminds me of a gas 3020.- Dr Gago
- Post #1
- Forum: John Deere
-
D
store closed
Do you judge a machine by the hour meter? Or the wear that a machine shows? With this newer equipment you can check the serial numbers with another dealer and get the previous owner contact number and call them directly if you are unsure of a piece of equipment.- Dr Gago
- Post #1
- Forum: John Deere
-
D
store closed
Have bought equipment from JDEquipment, good people to deal with, and they are 3 hours away from me.- Dr Gago
- Post #1
- Forum: John Deere
-
D
Round and square tube wide fronts
John Deere introduced the square tube front end in 1955 with the introduction of the 70 Diesel. The increase weight of the diesel engine prompted the introduction of a heavier wide front assembly. They will show up in the parts books as an updated assembly but NOT in the original parts books.- Dr Gago
- Post #1
- Forum: John Deere
-
D
3020s: This make sense to you?
You would be lucky to get $4000 for a "plain Jane" gas 3020. I would just keep the gas syncro around until I found a nice Diesel 3020. Gas/powershift is a gut less wonder.- Dr Gago
- Post #1
- Forum: John Deere
-
D
Nose chipped on used cars...
Maybe it was towed behind an RV?- Dr Gago
- Post #1
- Forum: Tractor & Farm Talk
-
D
OT How to deal with MIL to be that don't like you?
The Three S's....- Dr Gago
- Post #1
- Forum: Tractor & Farm Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy