(800) 853-2651
SHOP NOW

Recent content by DTK

  1. D

    More 504 problems

    Just got done putting on a Schwartz WF on the 504. Turns hard and squeals standing still on cement floor, when moving or jack up it steers fine. This is the same 504 w/ 3pt. This is the same 504 w/ 3pt and electrical problems.Thank you, DTK
  2. D

    More 504 problems

    Filters changed a year ago. Can you flush w/ diesel fuel? Thanks
  3. D

    More 504 problems

    Filters changed a year ago. Can you flush w/ diesel fuel? Thanks
  4. D

    More 504 problems

    Wide front is like new hardly used. Noise sounds like its coming from flow divider - pump area.
  5. D

    More 504 problems

    I am suspecting hyd issues . The wide front has not had much use. Check pressure with gauge in remote outlet? Steers very nice when moving. Seems to me it steered easier standing still w/ narrow front . This is the first it ran since last fall. Thanks Jim.
  6. D

    504 Farmall 3pt. Wont raise.

    Hi, 3pt. Hitch on 504 Farmall wont raise unless I move one of the remote levers. It lowers fine but wont raise when I use the 3pt lever. On a separate issue it wont shut off if I turn off key switch or disconnect the neg . Batt. Cable . It has a generator. If I unhook wire off of gen. It will...
  7. D

    504 Farmall 3pt. Wont raise.

    Ok thanks all
  8. D

    504 row crop/Schwartz wide front

    ISO good center steering arm to fit 504 Farmall andSchwartz wide front.This one faces to the rear. 504 has a different bolt pattern than an M and might be thinner. Thanks.DTK
  9. D

    #4 Massey Harris 10 pulltype swather

    Looking for a good canvas for 10 pulltype # 4 swather, also guards and begs. For rollers. Thanks, DTK.
  10. D

    #4 Massey Harris 10 pulltype swather

    Looking for a good canvas for 10 pulltype # 4 Massey swather, also guards and begs. For rollers. Thanks, DTK.
  11. D

    Metro quick hitch

    Looking for parts- latch handles and springs for a Metro quick hitch. Both sides. Thanks DTK.
  12. D

    # 4 Massey-Harris swather

    o you have any good sickle guards for A#4 swather? thanks .
  13. D

    Farmall 504 worm and sector

    ISO new worm and sector for a 504 row crop. Thanks DTK
  14. D

    504 wide front

    Does anyone have template for the front saddle of a Schwartz WF to fit a 504 row crop bolt pattern? 504 Farmall . Thanks DTK.
  15. D

    Schwartz WF on 504 row crop

    Do remember if it was much different than one that went on an M other than the different holes in the front saddle? Thanks DTK
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top