(800) 853-2651
SHOP NOW

Recent content by Eagle259

Yesterday's Tractor Forums
  1. E

    King Kutter Bush Hogger

    Thank you all for your input. The nut is off set close to the gear box. Trying to reach it with a socket is out. I'll need to reach it with a wrench that has the old 45 degree bend in it. I will run that tape again and I'll think out of the box to get the correct size. My Hogger is great however...
  2. E

    King Kutter Bush Hogger

    Hi all I need some help with one small issue. My Hogger was built in 1991 and I'm trying to find information and what size wrench I need to remove the blades. I have googled and have gone to King Kutter for information and I have yet to find my answer. Please let me know if you can guide me on this.
  3. E

    1944 2N not starting.

    Okay If I read this correctly I should change gap to .025 if I have a good spark then change it back to spec. Next is to check the fuel to make sure I have a good flow from the bottom of the carburetor. After that is the compression test. I'll start on this today and
  4. E

    1944 2N not starting.

    Here is the run down of what I have done. I have pulled the distributor set the tack and dwell to zero and adjusted the points to .015 gap. Set the carburetor back to factory settings. Took the battery in to the shop to make sure it was okay and they gave me a new one. Drained the fuel bowel...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top