edinmo's latest activity

  • E
    I'll lead off with my question: can the pto sliding drive gear be replaced with just 1st gear reduction area access? I'm considering...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    It has independent engine driven PTO. PTO drive gear on the crankshaft and idler pulley run anytime the engine is running..
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Thanks. Got the clutch totally off, put the driver disk back on, covered the fork assy mtg hole, ran the tractor and the growling is...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    I'll work on that. Of course that movement is basically at the outer end of the crank. So the actual movement at the bushing, which I'm...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Thanks for the input. The driver is very tight, no spline damage at all. Do you know of any suppliers of good main bushings other than...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    But with the clutch tightly engaged causing the clutch pulley to be tightly bound to the drive disk, wouldn't that eliminate all pulley...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Using a pry bar and dial indicator, I can engage the clutch and move the clutch up .017". Since the clutch is engaged the crankshaft...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    I agree. The noise volume inreases and decreases regularly and the frequency depends upon engine RPM. Sounds like something wobbling...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    I'll try moving the crank when I get the pulley off. I considered the crank main but I don't know why that wouldn't be a constant noise...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    My plan is to take the clutch pulley completely off, put the clutch driver disk back on, start the engine and see if it goes away. Any...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Seems like it has to be in the clutch or something in the 1st gear reduction gearing. Engine main noise would be constant I think.
  • E
    edinmo replied to the thread 630 rhythmic growl.
    You're right I need to get into it. I'd like to work the tractor for an hour or so to see if anything else may need work. Would that be...
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Here's a short clip. The clutch grabs and is jerky. I can lift on the clutch pulley and watch it move up and down. Is the clutch bearing...
    • Video Project 3.gif
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Yes, that rhythmic growl is always there.
  • E
    edinmo replied to the thread 630 rhythmic growl.
    Doesn't go away when the PTO is disengaged. It's there when in neutral with clutch engaged or disengaged. I'll work on posting a video.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top