(800) 853-2651
SHOP NOW

Recent content by elkcagg

Yesterday's Tractor Forums
  1. E

    John Deere R clutch parts

    Where can I find a clutch drive disk (with the gear) for an R? I was told Steiner has them but I’m not having luck seeing that. Is it possible to find an undersized one?
  2. E

    Case 1070 front end bearings need replacing

    How would you replace bearings in a front end on a Case 1070? Jack entire front end up to clear spindles from knee or remove the entire front end assembly? Thanks
  3. E

    New Holland 479 wobble box questions

    What are the telling signs of a wobble box going out? Mine was warm yesterday but could that be from normal use? I don't hear any unusual noises coming from it other than the sickle. I grease it every 5 acres. I did replace the bushing in sickle as I heard it knocking.
  4. E

    Vermeer 605G twine lost in tube every cutoff

    Thanks...No problems now sense I sharpened the knife. I greatly reduced the tension too. Works good now
  5. E

    New Holland 479 wobble box questions

    Will a wobble from a 469 work in a 479? I've never seen one apart to know if or how they can be rebuilt but as a machinist I'm very curious since these items bring more money than the machine is worth. I know a fellow who had a 469 that went out on him and I'm considering asking him if I could...
  6. E

    Vermeer 605G twine lost in tube every cutoff

    Thank you for the replies.
  7. E

    Vermeer 605G twine lost in tube every cutoff

    Hi, Trying to solve twine issue here & the book don't give any troubleshooting helps. How do you keep the twine from snapping back into the tube when it cuts off?
  8. E

    560 hydraulic issues

    I forgot to add to my original post...when the hydraulic oil gets really warm the engine labors some when the levers are actuated & after lever is in center position the engine continues to labor & takes a few moments to get hydraulic load off. Is my pump going bad?
  9. E

    560 hydraulic issues

    I have several hydraulic issues on my 560 Diesel. Baling hay today & the gate kept creeping open...the hydraulics weren't holding it locked so I figured I'd reverse the hoses so my lever would work opposite and they didn't? The baler gate still went the same direction after switching hoses...
  10. E

    Battery removal on 1170

    Thank you casecollectorsc, Are you referring to the bolt on the side of box about 6 inches from the front? Anyhow, knowing the box slides I think I should be able to figure it out. Thanks much again.
  11. E

    Battery removal on 1170

    I have 2 batterys that need replacing & was wondering how to remove them. No info in the I&T shop manual I have. I see 3 bolts on side that fender attaches to. Is this where I start? Thanks
  12. E

    Dodge County Fair Kasson, Minnesota

    I would like some feedback on previous turnouts & classes for tractor pulling at the Dodge County Fair in Kasson, Minnesota. I'm about 2-1/2 hrs away from Rochester & I would like to do some antique/improved class pulling near Rochester this summer so my sister can enjoy some time away from Mayo.
  13. E

    WIX pc-90 Oil fiter for Massey 44 on ebay

    Thank you for your confident reply BOB. Have a great day
  14. E

    WIX pc-90 Oil fiter for Massey 44 on ebay

    I just listed an oil filter for a Massey 44 on ebay. I think these are quite rare or discontinued from what I've read. Thanks
  15. E

    Questions about TA in 560's

    Thanks Farmall43. Makes sense to have the clutch looked at too if I need it split. Pedal is getting near the end unless I have some adjustment that can be made. I really like this tractor & it's certainly worth the repairs. I'm very impressed how how economical it is to run.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top