(800) 853-2651
SHOP NOW

Recent content by Ellsworth Chase

Yesterday's Tractor Forums
  1. E

    more 450 winter project pics

    I have done a complete restoration on a 57' 450 and a 52' Super C. You can view tractors on my web site "www.chaselinks.com" and browse the links. Feel free to email me for additional information. Untitled URL Link
  2. E

    Farmall Super C - FH Seat Support

    I have a Super C with a Fast Hitch. The seat support for a FH has a hole in the upper front of the box. What is that hole used for? I have been told that it was a place to put a manual crank, but that appears cumbersome as the crank will stick out and in the way. Any feedback will be...
  3. E

    Farmall 450 Amp Meter

    Well, I think the case is solved. You folks collectively hit the nail on the head. John Hagen and John T identified the specific issue, the load wire was on the wrong side. Now battery is on one post and the load and alternator output is on the other post. Amp Meter reads as expected. After...
  4. E

    Farmall 450 Amp Meter

    I will check connections again. Some easy to view and others in home made harness and I will need to trace with meter... I assume that if the wires are on the wrong sides, the needle would still move, just in the wrong direction.
  5. E

    Farmall 450 Amp Meter

    Thanks for feedback. In other research someone provided the following comment: "RARELY DO YOU GET ENOUGH CURRENT ON A TRACTOR TO CAUSE AN AMP METER TO MOVE". Maybe nothing is wrong. It will be helpful to see other feedback.
  6. E

    Farmall 450 Amp Meter

    I have a 1957 Farmall 450 with a 12v negative ground converstion using an 1 pole alternator. The conversion was done by the prior owner. The Amp Meter does not seem to register anything. I have checked voltages on both sides of the amp meter and both sides have 12+ volts. Using the volt...
  7. E

    super c factory snow plow-grader

    I have a C-72 Grader/Plow Blade on my Super C. It will mount on the front of under the middle. A very strong built attachment. Untitled URL Link
  8. E

    Super C touch Control

    Typical problem is the hydraulic pump o-rings are bad and the hydraulic fluid will leak into the engine crankcase. You can check the oil pan level petcocks. Don"t let the crankcase get too hith (full) else the seals will blow out. First replace the o-rings, next may need to replace the pump.
  9. E

    Power Steering for a Farmall Super c

    Do anyone have information regarding adding power steering to a Farmall Super C?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top