Recent content by Ennisda

  1. E

    hydraulic filter change

    i also see people talking about two drain plugs I found the one under the pot lever but where is the second
  2. E

    hydraulic filter change

    he issue with that theory is people are swapping the tin out taking the 135 tin and putting it on the 35's my tractor has the square good but has the round fenders. All the parts I've bought has been for. 135 except for the head and the guy told me the head is for a 35. There essentially is...
  3. E

    hydraulic filter change

    i know this sounds crazy but im not sure if I have a mf35 or a 135 serial plate is missing. any way the hydraulic fliud is milky so I drain and flushed with diesel fuel twice and I was goimg to change the filter but cant find it I was told it was behind the pto lever and I have that off but do...
  4. E

    cav injection pump

    is this something i can do or do you need special tools to get to the plungers
  5. E

    cav injection pump

    any body on here good with the cav injection pump on a mf 135. my tractor has been down for a rebuild for a couples of years finally got it all back together and went to fire it up and i have no pressure and very little fuel coming out the injector lines. it has new filters and i bled the air at...
  6. E

    mf-135 wont start

    also how hard is it to check the pluggers and metering valve do I have to pull the pump off to do this
  7. E

    mf-135 wont start

    I do have some fuel but just a dribble at all 3 injectors. also do you know which way is off on the fuel shut off on the injection pump
  8. E

    mf-135 wont start

    I finally got my second set of thrust washer in and got everything back together and it turn over just fine now and will start on starting fluid. I remind you that this tractor has been torn apart and setting in the garage for 3 years. I took the injector lines off and fuel dribbles out, is this...
  9. E

    mf 135 valve adjustment

    After taking everything back apart found the thrush washer was tore up again. Can't figure out why it keeps going threw thrust washers this was the reason for the whole rebuild to begin with and haven't even had it running and now I need another set of thrust washer and crankshaft work. Starting...
  10. E

    mf 135 valve adjustment

    Do you know if it takes two batteries or just one and also I took starter off and I can"t hardly turn it over by hand either getting frustrated
  11. E

    mf 135 valve adjustment

    ok ill try the 360 to see if that seems right i just know the 180 doesnt seem right. any ideas on the starter issue
  12. E

    mf 135 valve adjustment

    Ok im getting to the point of firing this old tractor up after a engine rebuld. couple od issues i would appreciat help on. When adjusting the tappets like the book said with #1 piston tdc i adjust 1,2,3,5 to .012 got that done but then it says to rotate 180 degrees when i do 4,6 valves are...
  13. E

    mf 135

    No i know where the tach is. this is a fitting if you take the valve cover off you will see a tube that run from the center of the rocker arm assembly to the rear of the head and connects to a compression fitting. that fitting goes straight through the head to the outside but mine doesnt have...
  14. E

    mf 135

    Hey guys i've posted on here before and recieved some good info im hoping for same results this time. I have a mf 135 perkins diesel and could use some wiring diagram for everything like alternator,starter,the glow plug on the intake,voltage regulator ect. also need to know if you are standing...
  15. E

    mf 135 head trouble

    I think the guy said he could repair it but no guarantees i think it was cracked in 2 different places. would like to find a new head
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top