(800) 853-2651
SHOP NOW

Recent content by Eric Bachhuber

Yesterday's Tractor Forums
  1. E

    Rottary Mower

    What type of oil should be used in the gear box of a 5' rottary cutter? I don't know the brand. I didn't see any past discussion of it in the archives. Thanx
  2. E

    How much wiggle is OK

    The orc/size adapter I put on the pto shaft of my 49 TO20 has quite a bit of play. From looking thru the archives this sounds common, but it really has a lot of play and causes the drive shaft for the mower to wiggle also. How much is excessive movement? Will I damage anything? Also I am...
  3. E

    Wiring

    I HAVE A NEWBY QUESTION. THE WIRING ON MY 49 TO-20 IS ROTTING AND WRAPPED IN DUCT TAPE. I HAVE THE MAPS TO FOLLOW TO REDO BUT I CAN'T FIND WHAT TYPE OF WIRE TO USE IN THE ARCHIVE. I REPLACED THE LARGER BATTERY CABLES, BUT WHAT KIND OF CABLE DO I USE B/W COIL, REGULATOR, IGNITION, GENERATOR...
  4. E

    steering wheel removal

    49 to-20 ---I removed the nut on top of the steering wheel, but I can not pull it off. I can't see anything else to loosen and the manuel just says to remove the nut and pull. Is there a trick to this? Thanx
  5. E

    Manifold

    Thanks for the input guys. I'm sure I'll have more questions as the project moves along.
  6. E

    Manifold

    Hi, I"m new to the forum. Just begining to restore a 1949 Ferguson TO-20. I put a new manifold on and the new manifold has a hole on the side bored out and threaded to take a 9/16 bolt. What is this for? The original manifold did not have this. Does anybody know if I should put a bolt in...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top