-
ErikL97 replied to the thread Anyone use their 8n to pull logs?.I have lots of trees down and need to clean up most of my property is a really steep hill which I’m gonna be using blocks and pulleys... -
ErikL97 replied to the thread Anyone use their 8n to pull logs?.Alright thanks fellas.
-
No diff lock so you'll only have 1 wheel drive, you can pull until you can't.
-
I’m sure you can unless they are huge. If you don’t already know. Just make sure you pick up the lead end off the ground so they don’t...
-
I’m wondering if anyone uses their 8n to pull logs. I got my 8n to do stuff around the new property and I needed a smaller tractor. I...
-
ErikL97 replied to the thread My clone carb.I’ve heard that before. I’ve took mine off and it’s been 180 off before and it went into the slot just fine and I’ve taken back off and...
-
If you try to force it when its 180 off you will do very serious damage to the distributor.
-
ErikL97 replied to the thread My clone carb.Will do thanks soaked
-
Agree check the timing. Remember the cam slots are offset, so the distributor shaft offset needs to line up one way only, if not, its...
-
ErikL97 replied to the thread My clone carb.Will do I will get back on it and will check it. Couldn’t get it to run just serval backfires out carb and exhaust. Thinking it’s...
-
3/64 is .0469, so yes. #56 drill is .046 too Ive had a couple that have .052 jet that run just fine. Haven't had a wrong size...
-
ErikL97 replied to the thread My clone carb.Okay I can't remember what size bits i just got back to working on the 8n after a few months of putting it off. Took everything off to...
-
Hi ErikL97, Stock 9n9914 econo jets I've bought are .046". If too big, engine leans out, and if too small, runs richer than desired...
-
My eco jet is plugged? Compared to my broken original it doesn't match should I drill it out with correct drill bit
-
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy