Recent content by ernestmm

  1. E

    U hydraulic

    Need to find alternative to mm hydraulic cylinder for my old U's. It seems that this "hydraulic lock valve" is the ticket?
  2. E

    Nh 68 hayliner clutch

    Thanks, but that's quite far. I'm in the middle of montana🙂
  3. E

    Nh 68 hayliner clutch

    Yes. You are right. 4 is what I'm talking about. I should have looked at the pictures more closely. I will get one and get the old girl going. Thanks
  4. E

    Nh 68 hayliner clutch

    Looking for the slip clutch plate for my super 68 hayliner baler. It is part number 227020. Its the pto slip clutch plate for the 2 pins. The part number for a new one crosses to one with 3 pin notches and says that is better and works. My yoke is only 2 pins. Is it true that the 2 pin yoke will...
  5. E

    Mmg water pump not pumping

    The impeller is tight. It is the shaft that is definitely a problem. IT has a lot of end play, and the impeller is worn to a knife edge. And im assuming that end play allowed it to wear into the pump housing. I'm replacing pump front housing, shaft, both seals, bushing, and impeller. The...
  6. E

    Mmg water pump not pumping

    My mmg is not circulating water. It has that big thermostat housing kinda like on the gvi that I can't find. Has a bypass tube from there to the pump. Deleted both cause I can't find a thermostat. Water didn't circulate before and won't now. Water seal in pump with spring was replaced. Opened it...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top