Recent content by Eugene Johnson

  1. E

    Model H Electrical Puzzle

    Thanks John. Am shopping for an overnite switch. Best regards , Gene
  2. E

    Model H Electrical Puzzle

    Thank you for the additional information. Off the "Load" terminal it comes. This forum is a Blessing. Best regards, Gene
  3. E

    Model H Electrical Puzzle

    Thank you for the guidance: It is wired as a 6 volt neg ground. I did not polarize - will now I believe the cutout is original -m 6 volt ps: When I say load side I meant I attached the field wire to the "lights" side of the on/off switch that would not be continuously hot. Best...
  4. E

    Model H Electrical Puzzle

    I installed a new wiring harness on 1947 Model H. With engine running the ammeter shows charging. With engine not running and lights ON ammeter shows reasonable discharge. However with lights and engine both ON the ammeter pegs erratically at the discharge limit which I assume is a bad thing...
  5. E

    John Deere Model H axle spacing washer

    Thank you for the explanation. Still learning at 84. Gene
  6. E

    John Deere Model H axle spacing washer

    Thanks so much - I will check it out. Gene
  7. E

    John Deere Model H axle spacing washer

    Hello, On reassembly of the model h right rear axle I found that I did not have item 27 "Differential spacing washer". Is there a possibility that it is not used (or did I lose it? This is a 1947 model. Thank you for the help. Gene
  8. E

    John Deere Model H exhaust

    Pete in MD, Thank you. Good to know the loose fit at muffler is OK. Gene
  9. E

    Decals for 1947 Model H

    Thank you. I will give him a try. Gene
  10. E

    John Deere Model H exhaust

    I have a muffler and exhaust pipe for the Model H = the exhaust pipe fits loosely in the muffler with not apparent seal - is this correct? Thank you for the help.
  11. E

    Decals for 1947 Model H

    I received decals for our 1947 model H from Yesterday's Tractors - the main hood decal font is roughly 1/2 smaller than the orignial on our '47. Can anyone one tell me if there a source for exact size decal?
  12. E

    JD Model H piston ring installation

    Got it. Thank you. Gene
  13. E

    JD Model H piston ring installation

    Thank you. Problem solved. Gene
  14. E

    JD Model H piston ring installation

    We found light rusting in one cylinder and at this point intend to hone the bore and install new rings. There appears to be two ways to install rings, i.e. move the block forward and access the piston without removing the connecting rod from the crankshaft OR remove the connecting rods from the...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top