(800) 853-2651
SHOP NOW

Recent content by F-12 guy

Yesterday's Tractor Forums
  1. F

    240 lift arm shaft pin

    Hello, My father in law is wanting to remove the lift arm shaft pin on his 240 does anyone know how to go about this. It just turns now, will not back out. The pin I'm asking about is under axle shaft on side of rear end that the lift arm goes on. Thanks Josh
  2. F

    F12 sleeve diameter

    Does anyone know the OD and ID of a farmall F12 sleeve? I"m needing to get a puck made for my sleeve puller. Thanks Josh in Nc
  3. F

    f12 hyd. lift which fuild

    Which fuild do you use in a hyd. Lift on a f12? I thought i read somewhere 80/90 but want to be sure. I'm guessing you fill to bottom of full hole also. Thanks for the help. Josh
  4. F

    f12 carb trouble

    Thanks for the info. Is it just a little brass plug? I have one out of another carb that will fit it. Another question when u set your float height, did u set it with float up or down. Thanks. Josh
  5. F

    f12 carb trouble

    I been working on my f12 trying to get it to crank. I put a new diafram in the fuel pump, its pumping fine now. Well I tried to crank it yesterday and never could it to run. I have good spark, and fuel to carb. I took carb. Back off and apart I think I am missing a part in carb. The hole in...
  6. F

    f-12 fuel pump question

    TI have a f12 I have been working on, I'm haveing trouble with fuel pump. When I turn gas on at tank the fuel strainer fills up and then gas will start to run out vent on bottom left of pump body if you are looking at pump on tractor. My gas lines are clean. I can crank on tractor and gas...
  7. F

    new toy home, farmall f-12 pics

    No she does not run now. The motor was stuck, I got it free and had to have valve seats worked on. I hope to try to crank her by weekend. Josh. Here is a pic of my son helping me work on it.
  8. F

    new toy home, farmall f-12 pics

    Went and picked up this F-12 about a mounth ago. Thought I would post some pics. She is a 1937 model.
  9. F

    IHC Grain binder found

    In barn
  10. F

    IHC Grain binder found

    One more
  11. F

    IHC Grain binder found

    Another try for pictures
  12. F

    IHC Grain binder found

    I finaly have some pictures to post. Sorry it took me so long. Does anyone know the model of binder this is?
  13. F

    IHC Grain binder found

    I have found a IHC grain binder in a small barn about 6 miles from my house. I'm going to try to get it out today, barn is about to fall on it so we have to do some bracing. Looks to be in good shape from what I can tell its just missing some of the wood where water got to it and the canvas...
  14. F

    Fast hitch 3 disk plow help

    I have a 3 disk plow, I have been trying to plow with it some. The plow wants to jerk to front of my tractor around. How should the tail wheel be adjusted? Now it is ridged and is not following the last bottom. I believe this is what is jerking the front of the tractor around. I'm not sure...
  15. F

    trip to Virginia

    The Frontier culture museum in Staunton Va. Its off of 64 on your way home. http://www.frontiermuseum.org/
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top