-
F
CORUNNA FOUL PLALY !!!!!!!!!!!
I have had my carb messed with before. My main jet was screwed all the way in and my load screw was turned as well. I caught this before I hooked the sled cause I always hold down on the breaks and let the clutch out slowly in a high gear before I cross the scale before I hook. If the tractor...- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
Gary Baker Parts
I've known Gary for quite some time and I will say he is one of the most straight shooting guys you will ever meet. I've had the privilege run a tractor of his before and let me tell ya what a masterpiece. The knowledge and the know how of that man are endless. I would highly recommend him to...- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
farmall head?
What bore size do you currently have? Also when you put to big of bore with a big step on the pistion and shave a stock H head down you will also need to chamfer the ridge in the combustion chamber so the piston don't hit it. Hope this helps a bit.- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
ever pulled this sled?
What about the 3 foot chain? Takes way more power and front end weight. I do not not pull that sled much any more cause I built my motor 2 years be for the switch in sleds and after $2500 I really did not want to redue the motor again. I am finding dead weight pulling more fun with that tractor...- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
Which state produces the best pullers?
I think Michigan pullers can run with the best of them as well.- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
Farmall Super M question
Thank all of you guys that was a big help. Ryan- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
Farmall Super M question
Thank you guys. I do have one other question about the 4-1/8 bore will the sleeves drop in with out boring the block?- Farmall Ryan
- Post #1
- Forum: Tractor Pulling
-
F
Farmall Super M question
I am looking to buy a super m for pulling in amtique 5000#-6000# classes and was wondering about how much horse power I would have with 4 1/8" high dome pistons, stock stroke, shaved head, and a Baker cam. Or would I be better off doing something different? All ideas will be helpful. Thank you...- Farmall Ryan
- Thread
- Replies: 7
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy