(800) 853-2651
SHOP NOW

Recent content by Farmall65

Yesterday's Tractor Forums
  1. R

    Jubilee-Radius Arm Pin

    I am widening the track of a Jubilee to 6 feet. It is suggested to move the radius arms to the outside holes. I have the nuts off the radius arm pins on the front axle...but cannot budge them with a pretty firm hammer. Do I just need a bigger hammer? ...or am I missing something? Thanks! Rich
  2. super99

    generator ground rod

    I need a ground rod for my pto generator. I'm looking on Farm & Fleet website and they have 8' galvanized rod, 6' copper round rod, 8' copper clad steel ground rod. Which one would be better? The neighbor has beans in my bin and and one leg of the power is dead, so I figured I would try out the...
  3. F

    7 point plug on 766

    I'm hooking up a 7 way plug on a 766 IH to power hazard and taillights for a kinze planter. I've got the green, yellow, and brown wires hooked up to a hot wire on the headlight switch and got the ground (white wire) grounded. The issue is the hazard lights dont flash, they are solid and the...
  4. F

    7 point plug on 766

    I'm hooking up a 7 way plug on a 766 IH to power hazard and taillights for a kinze planter. I've got the green, yellow, and brown wires hooked up to a hot wire on the headlight switch and got the ground (white wire) grounded. The issue is the hazard lights dont flash, they are solid and...
  5. F

    IH 1066 Shifting Issues

    Yes light does work and come on. Where is the link in the archives that you have?
  6. F

    IH 1066 Shifting Issues

    The clutch booster was rebuilt by local case dealer. Installed it back on the tractor and now whether its in forward gear or reverse tractor randomly stops as if your pushing in the clutch pedal. Brakes and steering work as they should. Also check the hytran fluid level and it is good...
  7. F

    Cub 184 motor in cub lo boy

    Will a 184 cub motor fit in a 1960 cub lo-boy?
  8. F

    Getting the crank extension loose

    Patience and Penetrating oil is key!
  9. F

    M Popping

    It does have a magneto and not a distributor.Is this normal for it to pop, as I have heard it is common for these old tractors do so oppossed to a having distributor?
  10. F

    M Popping

    Whenever my M runs for a little bit, it goes to popping. It isnt super severe but Id like to diagnose the problem. Heres what i have done so far.. Pulled valve cover and adjusted the valves, new plugs and wires, rebuilt the carb along with cleaned the fuel line, tried adjusting the timing but...
  11. F

    H Restoration

    Anyone have any tips or suggestions when sandblasting a H for the first time?
  12. F

    Re: M steering gear? add grease or 90 oil?

    I put grease in it
  13. F

    H Camshaft Gear

    To get to the camshaft gear inside the front timing cover, do the front wheels needs to come off the rails? I need to replace the camshaft gear and Im gonna pull the one off a parts tractor.
  14. F

    Splitting Stands

    Anyone got any homemade splitting stands that theve made? Specifically for farmalls.. Tanner
  15. F

    1944 H Timing

    I recently took front timing cover off along with the camshaft gear,idler gear,plate behind the gears and the distributor. This was done to replace the 2 gaskets on the front of the engine. Was pretty positive when I put it back on, that the gears were all timed correctly. Now it just backfires...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top