(800) 853-2651
SHOP NOW

Recent content by farmallstrong

Yesterday's Tractor Forums
  1. F

    ford 600 coil

    I have a ford 600 and my question is, does the coil have a built in resistor ? If not does it need one? Tractor is 6 volt. I tuned it up with new plugs, wires, points, condenser, cap, rotor , and coil. It ran good for a few months. Now it won't start and has a very weak spark. This tractor...
  2. F

    ford 600 distributor

    Thank you
  3. F

    ford 600 distributor

    What is the rotation of the distributor, clock wise or counter clock wise ? Also does anyone have a picture of the cap with number 1 in the proper place. thanks for any help.
  4. F

    wheel horse manual

    I need a parts manual for a wheel horse c 165 tractor. Where can I find one? Thanks
  5. F

    How many have a 67 year old mower ?

    I mow with a 1946 farmall B and a woods L59 mower. The tractor is 71 years old. I change the oil and Plugs every year. It is not restored and starts right up. I trim with a 1978 cub cadet with a 48" deck. I mow 2.5 acres.
  6. F

    BN C rear ends

    Are the ring and pinon the same in the BN and C ?
  7. F

    nye pipe cutter wheels

    You can try Reed pipe cutters in Erie Pa. or Imperial pipe cutters, or Ridgit pipe cutters.
  8. F

    240 rear axels

    Thank you for your reply. This will be very helpful. Do you know of any other tractors that use these axles?
  9. F

    240 rear axels

    Are there any other axels that will fit a farmall 240 besides the 240? Are the 240 utility rear axels the same other than the hubs? thanks.
  10. F

    pex

    I use Zurn pex pipe and plastic fittings. There are 2 rings that can be used both require a clamping tool. The thin ring will slide on the pipe and you must put it where you want it. The wider ring has stops on it so it only goes on so far. Both rings take a clamping tool just for it. There is...
  11. F

    1 wire alternater

    Thanks for the reply. The mini ones that you used do they use a 5/8"belt? If they do what brand and model are they?
  12. F

    1 wire alternater

    What 1 wire alternator with a 5/8" wide belt pulley width do I need. This is going on a 140 Continental Flathead.
  13. F

    length of delco generator.

    I have cockshutt 20 deluxe that I want to put it on. It was a 6 volt system that the past owner put a 12volt battery in. I was told it was converted to 12 volt, but it had a 6 volt generator that was junk. They put 12 volt pertronics and a 12 volt coil in it. So I would like to put a 12 volt...
  14. F

    length of delco generator.

    Can you get the length for the short one? What voltage regulator do they use ?
  15. F

    Carb and manifold size

    We pull a BN with a c135, we used a 444 manifold that we match ported and polished. Do the same to the carb. WE run 16.9 X 24 tires.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top