(800) 853-2651
SHOP NOW

Recent content by farmboy48

Yesterday's Tractor Forums
  1. M

    Plow rear wheel perhaps

    Got this Ferguson plow and I am wonder if there was an option for a rear wheel for a more consistent debt thanks for any info
  2. J

    Spark Plugs

    Looking for 4 NOS Champion 34 spark plugs for a project. Any plug collectors out there??
  3. F

    new to me 8n

    Thanks guys for your info, I got the I&T manual, but you make it clearer. Now I just have to find the parts, assuming I will also need gaskets and seals and whatever looks like it should be replaced. Don't have any dealers in the area I know of so will have to research that. Dick
  4. F

    new to me 8n

    Hi guys, I am usually on the farmall forum, but recently picked up what I think is a 1948 8n, hasn't run in 20 years but engine is free. but it has a bad oil leak from right side of differential where the arms to the three point are attached. Seems really loose, any info on what to do to stop...
  5. F

    Stuck clutch on M

    I had to replace the clutch on one of my m's last summer, as the fingers on the pressure plate were worn off, in taking apart, 2 of the bolts from clutch to flywheel snapped off, last guy must of torqued them to 150 ft lbs or so. After I got the new clutch in place and bolted with the remaining...
  6. F

    Farmall H Question

    had the same problem with one of my m's, finally after trying all the usual stuff, I took carb off, poured water in exhaust, it just poured out of the intake side (bottom) of manifold. determined the manifold had a hole in it between intake and exhaust sections. found a good one for 20 bucks...
  7. F

    Making it fit

    Did that quite a few times in years past, it would take me half a day to get up there now, and my back would give out long before I got her leveled out. LOL
  8. F

    6600 with 329 motor

    my 6600 has the 329 diesel, and no problems with 20 foot header in beans, flax, wheat, canola. The old girl just keeps on threshing. Had to have the injector pump rebuilt this fall, but lack of power was not the issue. Just kept stalling on me. Dick ND
  9. F

    Do I dare ask?

    I have an IH 1466, Case 930, 3 m's, and a w6. I like and use them all for different jobs, really enjoy making the old 930 snort pulling 18' chisel plow tho. Dick ND
  10. F

    John Deere 6600 combine, engine dies

    thanks for the help guys, looks like the pump is dying, gonna take it to repair shop in the morning, they guesstimate about 600 bucks to overhaul. Not too bad a price if they get it right. Dick ND
  11. F

    6600 John Deere diesel dying

    thanks for all the replies, looks like it is going to rebuild shop tomorrow. Tried all the suggestions here and from JD forum looks like pump needs repair. Dick ND
  12. F

    6600 fan speed?

    I run my 6600 diesel at 2500 rpm's fan is about 850 rpm's
  13. F

    6600 John Deere diesel dying

    Bob, been thru all that, but curious what is "BLEM" haven't encountered before. Dick
  14. F

    John Deere 6600 combine, engine dies

    yep, good flow out of sediment bowl outlet, vent seems ok, even tried it with fuel cap off to eliminate possible vacuum in tank. Electric pump filled new filter in less than ten seconds. I was advised to check return line check valve for rubber bits from dampening ring in injector pump, will...
  15. F

    6600 John Deere diesel dying

    thanks, I will check it out in the morning. Dick ND
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top