Recent content by farminhard

F
ih 3414

this has a backhoe on it just need something that would run the hoe
- farminhard
- Post #1
- Oct 2, 2020
- Forum: Farmall, International & McCormick
F
ih 3414

would a motor out of a 240 or a 340 fit
- farminhard
- Post #1
- Oct 2, 2020
- Forum: Farmall, International & McCormick
F
ih 3414

looking to find out what motor will fit in a 3414 ih
- farminhard
- Thread
- Oct 2, 2020
- Replies: 5
- Forum: Farmall, International & McCormick
F
660 combine

yes 2/38 new holland head would like to find a case head
- farminhard
- Post #1
- Dec 20, 2014
- Forum: Combines and Harvesters
F
660 combine

660 case running corn
- farminhard
- Thread
- Dec 20, 2014
- Replies: 8
- Forum: Combines and Harvesters
F
pic just home from auction

fordfarmin was the auction at johnstown
- farminhard
- Post #1
- Oct 26, 2013
- Forum: Tractor & Farm Talk
F
ford 6000

the 223 gas gasket will not work ford new holland sould be able to get one for the diesel
- farminhard
- Post #1
- Oct 19, 2013
- Forum: Tractor & Farm Talk
L
Craftsman lawn tractor model 917.249392

I am a bit confused, I googled my Craftsman Ridng lawn mower model 917.249392. This model # comes up showing it as a grass bagger? This is the number I took from the mower I need a manual for it so I can adjust the brakes. Lloyd
- lloveday
- Post #1
- Jun 9, 2013
- Forum: Tractor & Farm Talk
F
6000 pto speed

that is the pto load power selection lever forward notch selects 2225 engine rpm rear notch 1730 engine rpm to get 1000 pto you have to have the 1000 rpm stub shaft if you have the lever in the rear notch you do not run engine over 1730 rpms if you do it turns the pto faster then 540 rpms my...
- farminhard
- Post #1
- Jul 13, 2011
- Forum: Ford
F
Corn

openpollinated.com
- farminhard
- Post #1
- Apr 27, 2010
- Forum: Combines and Harvesters
F
6000 engine rebuild

it goesin front of the timing gear that would put it right behind the front seal
- farminhard
- Post #1
- Dec 1, 2009
- Forum: Ford
F
oliver oc3 - oliver super 55 gas engine

the oliver 66 bell housing will fit the super 55 moter they are the same block
- farminhard
- Post #1
- Nov 26, 2009
- Forum: Oliver, Cletrac, Co-op and Cockshutt

Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy